28562
48
Zoom out
Zoom in
Previous page
1/178
Next page
Simrad SP60
38
850-164575 / Rev.D
Start and stop procedures
Note Before you start the sonar, check that the water depth is
sufficient, and that the vessel’s speed is within the maximum
speed specified with the transducer lowered.
Start procedure
Observe the following procedure to power up the sonar.
1 Press the Power button on the monitor to power up the
display monitor.
2 Press and hold the red Power button on the Sonar
Operating Panel for approximately two seconds to start the
sonar.
- The green LED next to the button indicates that the
sonar starts loading the program. After approximately
one and a half minutes the sonar picture will be
displayed.
3 Press the Down button to move the transducer to the lower
position.
- The green LED next to the button will flash, and an
audible signal indicates that the transducer moves
downwards.
- Observe that the TX Power: Off buttoninthe
Horizontal menu starts to flash. In order to prevent
inadvertent start of the transmitter, the transmit power
is automatically switched off when you power up the
sonar.
- When the bottom position has been reached, the LED
will illuminate continuously, the audible signal stops,
andthetopbuttonintheStatus parameter dialogue
shows: Transducer: DOWN.
4 Set TX Power to Full in the Horizontal menu.
This completes the normal start-up procedure.
Middle
Up
Down
MAIN SW.
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SP60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SP60 in the language / languages: English as an attachment in your email.

The manual is 3,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info