28560
161
Zoom out
Zoom in
Previous page
1/224
Next page
SL 30/35 Hull Sonar Operators Manual 974-25007001/2.0
Installation, Start-Up and Test Page 6.13
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
tank, taking care not to damage the sonar dome
Attach the tank flange assembly to the retraction tank using the supplied hex
bolts, flat washers, spring washers and nuts; do not over tighten the bolts,
otherwise you will damage the flange gasket.
Next, position the sonar dome into its final position, by adjusting the V Guide
alignment block. Ensure that the sonar dome is fully retracted into the sonar tank
Note: Apply Loctite, Nickel Anti-Seize to the threads of the hex bolts before
assembling.
The main shaft bearing must be greased. Remove the Vent Cap located on the
opposite side of the grease fitting. Using the supplied Shell “SRS 2000” water
resistance grease, fill until the grease comes out from the vent; re-install the
Vent Cap.
See Part 8 “Attachments and Drawings” for detailed assembly information.
6.4.5 Mounting the Hoist Unit
A mounting pad is incorporated into the tank flange in order to secure the
lower/raising ram assembly.
To secure the lower/raising assembly:
Insert the clevis pin into position and secure in place by installing the hair-pin clip
supplied with the system
Install the Vent Cap on the oil reservoir, then manually raise the RAM unit by
using the manual hand pump located on the hoist unit to its full “UP” position
Slide the upper hoist retainer clamp from the top of the shaft into position
Secure the upper part of the hoist unit in place using the clevis pin and hair-pin
clip. Fix the upper shaft and hoist retainer clamp using the supplied hex bolts, flat
washers and lock nuts; apply Loctite Nickel Anti-Seize to the threads of the hex
bolts and the shaft before assembling
Next, mount the Ram Alignment Guide on the Ram hoist unit; additional care
must be taken to properly align the hoist unit
Install the cable gland on the top of the shaft
See Part 8 “Attachments and Drawings” for detailed assembly information.
161


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SL35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SL35 in the language / languages: English as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info