28538
49
Zoom out
Zoom in
Previous page
1/176
Next page
Operation
39
850-164385 / Rev.C
Disconnected mains
In case of power failure, or if the mains plug on the Sonar
Processor Unit has been disconnected, the sonar must be started
by pressing the start switch S101. This switch is located behind
the small front panel on the Sonar Processor Unit.
The location of the S101
switch on the front of the
Sonar Processor Unit.
(CD15006)
S101
Design change
On sonars shipped from Simrad before August 2003, the
APC10 Sonar Processor Unit is used. This unit is also equipped
with an “on/off” switch behind a front panel. It has also an
additional “master on/off” switch on its rear panel. Instead of
disconnecting the mains plug, this switch can be set to “off”.
Stop procedure
1. Press the Up button on the Sonar Operating Panel to hoist
the transducer to the upper position.
- The green LED next to the button will flash, and an
audible signal indicates that the transducer is hoisted.
When the upper position has been reached, the LED
will illuminate continuously, the audible signal stops,
and the upper button in the Status menu shows:
Transducer: UP.
2. Press and hold the Power button approximately two
seconds to switch off the sonar.
3. Check that the green LED next to the On/off button
extinguishes.
4. Press the Power button on the display monitor to switch it
off.
Warning: If the sonar is switched off uncontrolled with the
transducer lowered, the transducer must be
raised by means of the hoist/lower switch in the
Motor Control Unit, or with the hand crank.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SH80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SH80 in the language / languages: English as an attachment in your email.

The manual is 2,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad SH80

Simrad SH80 User Manual - Spanish - 180 pages

Simrad SH80 User Manual - Norwegian - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info