28536
10
Zoom out
Zoom in
Previous page
1/40
Next page
Simrad SH40
POWER ON/OFF
This chapter explains how to switch your sonar system on and off.
WARNING
Before you start: Make sure that the water
depth below the keel is sufcient to l ower the
transducer!
Howtoswitchonthesonar
Observe the following procedure.
Middle
Up
Down
MAIN SW.
POWER
A
B
C
D
(CD015022B)
1 Press the Power button on the colour display monitor.
2 Press the
Power button (A) on the Sonar Control Panel, and
keep it depressed for approximately two seconds.
A green lamp will ash to indicated that the power has
been switched on, and that the computer is starting up.
After a short period (approximately 2 minutes) you will
see the sonar picture on the display.
3 Press the
Down button (D) on the control panel to lower
the transducer.
The transducer will stop automatically when it has
been lowered to its full length. The dialogue at the
bottom right corner of the display will tell you when the
transducer has been fully lowered.
By default the transmit power is disabled when the sonar
is powered up. This is for safety reasons. In the menu,
you will see that the
Transmit power button ashes to
remind you of this.
4 Set
Transmit power to On.
8 302656/A
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SH40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SH40 in the language / languages: English as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info