621496
23
Zoom out
Zoom in
Previous page
1/132
Next page
Autopilot Operation
22081814H 21
2.2 AP300X with MSD50 Stern Drive unit
Note ! The information on this page applies if your autopilot is driving a Robertson
MSD50 Stern Drive.
The MSD50 Stern Drive unit has a relative feedback signal which
needs a zero point setting after the autopilot has been turned on.
Refer to page 1-1 of the MSD50 manual for further information.
Zero point setting
Note ! If you do not need a rudder angle display when leaving the dock, just
steering the boat manually on a straight course and press the AUTO button.
The zero point is then set automatically.
If you prefer to use the rudder angle display when leaving the dock,
proceed as follows:
After turn on press the STBY button once more to display the rudder
angle.
10
STBY
Display is alternating between port and starboard rudder to indicate
that the “rudder” zero point need be set.
Use the wheel to bring the “rudder” to midship position: Turn the
wheel from lock to lock (H.O. to H.O.) and count the exact number of
turns. Then start from one lock position and turn the half number of
turns.
Press AUTO and then STBY two times with an interval of approx. 2
seconds between the two. The zero point is now set and the display
will read:
00
STBY
Operation
Use the operation instructions on the following pages. There is no
need for further zero point setting until next time you turn the
autopilot on.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad Robertson AP300X Marine Autopilot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad Robertson AP300X Marine Autopilot in the language / languages: English as an attachment in your email.

The manual is 4,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info