23336
275
Zoom out
Zoom in
Previous page
1/322
Next page
PI Configurator
263
850-165186 / Rev.B
Making a programming cable
Should a Simrad programming cable not be available, it is
possible to make an adequate substitution as described below.
It is only possible to make programming cables for stationary
computers. If you wish to use a portable computer the cable
must be ordered from Simrad. Some new stationary computers
have been found to provide the same output specifications as
portable computers using lower voltage on the serial line. On
these computer s, a portable” cable is also required.
You will need the following parts:
A 9-pin, Sub-D female connector
Approximately one to two meters of 2-wire cable
A 3 kohm resistor
Two alligator clamps
The cable assembly procedure is as follows:
1 Connect pin number two of the 9-pin, Sub-D female
connector to one end of the positive (+) lead of the 2-wire
cable. At t he other end of the positive (+) lead, connect
the positive (red) alligator clamp.
2 Connect pin number five of the 9-pin, Sub-D female
connector to one end of the negative (-) lead of the 2-wire
cable. At the other end of the negative (-), connect the
negative ( black) alligator clamp.
3 Connect the 3 kohm resistor between pins number two and
three of the 9-pin, Sub-D female connector.
4 Check both alligator clamps and r espective pins for
continuity.
275


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad PI54 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad PI54 in the language / languages: English as an attachment in your email.

The manual is 10,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad PI54

Simrad PI54 User Manual - Norwegian - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info