23336
247
Zoom out
Zoom in
Previous page
1/322
Next page
PI Configurator
235
850-165186 / Rev.B
How to interface the sensor
Before you can configure the sensor, you need to connect it to
the computer. Observe the procedure below.
1 Start the PI Configurator utility.
2 Plug the programming cable into one of computer’s COM
ports (COM1 is recommended).
3 Ensure that the sensor to be connected is switched off.
Check that the internal LED does not flash, and that the
sea water s witch is not activated in any way.
4 Attach the programming cable’s positive (red) alligator
clip to one of the sensor’s positive fastening lugs
(designated with a plus symbol).
5 Attach the programming cable’s negative (black) alligator
clip to one of the sensor’s negative fastening lugs
(designated with a minus symbol).
6 In the PI Configurator utility, click the Communication
Port Setup button to open the ComPortSetupdialogue
box.
7 Select the COM port the programming cable is plugged
into by clicking it, then click OK.
8 Observe that the Establish Communication with Sensor
button has been activated.
9 Click the Establish Communication with Sensor button.
Small dialogues will tell you that the computer first opens the
COM por t, and then wakes up the sens or. If there is a
malfunction, you will be notified accordingly. Once the
communication between the PC and interfaced sensor is
established, the yellow text field will display the key parameters
retrieved from the sensor. Also, the indicator lamp in the lower
right-hand corner of the PI Configurator dialogue will turn on
and off every two seconds. The indicator lamp inside the sensor
will illuminate at the same rate.
247


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad PI54 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad PI54 in the language / languages: English as an attachment in your email.

The manual is 10,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad PI54

Simrad PI54 User Manual - Norwegian - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info