39209
86
Zoom out
Zoom in
Previous page
1/122
Next page
IS15 General Manual
84 20220760L
Interfacing to a Simrad AP11 or AP 20 series
autopilot
Use a single cable with two twisted pairs of wire for this
connection.
NMEA Out
The connection will provide speed, depth, temperature and wind
data input to the autopilot.
With a J3000X Junction Unit in the system the autopilot will
also receive GPS data via this connection provided a
GPS/chartplotter is connected to the Expander.
The connection is made to the J3xx Junction Unit Main Board,
Terminals RX1+ and RX1-.
NMEA In
This connection provides heading data input to the instruments.
The connection is made to the J3xx Junction Unit Main Board
terminals TX1+ and TX1–.
Figure 6-29 Simrad Robertson “X” series autopilot connection
Note !
With a J300X Junction Unit in the autopilot system you may
have redundancy and a higher heading output rate if you run a
separate and direct NMEA interface between the chartplotter
and the autopilot.
In that case connect the IS15 Expander to J300X, RX2/TX2
instead. Connect the chartplotter (port 1) to IS15 as shown in
Figure 6-12. In addition connect the chartplotter (port 2) to
J300X, RX1/TX1. On the autopilot and the chartplotter the
interfacing must be set up accordingly.
86


Need help? Post your question in this forum.

Forumrules
1

Forum

simrad-is15

Reset search

  • Simrad is15 multi???
    How do u convert display depth meters to feet?
    Help Submitted on 17-6-2023 at 13:49

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad IS15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad IS15 in the language / languages: English as an attachment in your email.

The manual is 2,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad IS15

Simrad IS15 User Manual - German - 112 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info