621454
28
Zoom out
Zoom in
Previous page
1/56
Next page
Motor output
Shows the amount of power needed to achieve the correct rudder
speed. The reading is obtained from the Rudder test.
The automatically set value may be increased or decreased.
Rudder deadband
This parameter is used to prevent the rudder from hunting. The
reading is obtained from the Rudder test which optimizes the
deadband to the speed of the boat and the pressure on the rudder.
If the auto-setting does not perform properly due to high inertia
from the wheel or a loose steering gear, it can be adjusted manually.
Find the lowest possible value that will prevent the rudder from
continuous hunting. A wide deadband causes inaccurate steering.
Ú
Note: The rudder deadband setting is not available when
the autopilot is configured for Virtual Rudder Feedback.
Seatrials
A seatrial can only be performed if the dockside settings are
completed and confirmed. The seatrial must always be performed in
open waters at a safe distance from other traffic.
Ú
Note: You can switch the autopilot to standby mode and
take manual control of the boat at any time during the
seatrial by pressing the STBY key on the OP40.
The following seatrial calibration should be done:
Compass calibration; used to automatically compensate for on-
board magnetic interference
Compass offset adjustment, used to compensate for a fixed
offset in the final heading readout
Wind vane offset is to compensate for a wind vane that is not
mounted facing in exactly the same direction as the bow of the
vessel (dead ahead)
Boat speed calibration
Transition HI/LO speed setting (the speed at which you want to
change the set of steering parameters)
Automatic tuning of the steering parameters
Setting the seastate filter
Sailboat Setup menu items
28
Software Setup | GO7 Installation Manual
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad GO7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad GO7 in the language / languages: English as an attachment in your email.

The manual is 2,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad GO7

Simrad GO7 User Manual - English - 122 pages

Simrad GO7 Quick start guide - English - 40 pages

Simrad GO7 Installation Guide - German - 68 pages

Simrad GO7 Quick start guide - German - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info