621454
26
Zoom out
Zoom in
Previous page
1/56
Next page
- The boat type setting is used by the system to select
appropriate preset steering parameters. It also affects
available autopilot features.
4. Perform the rudder calibration.
- Used if you have a rudder feedback unit installed. This
calibration is used to ensure that the physical rudder
movement corresponds to the rudder angle displayed on the
GO7 unit.
-
The Virtual Feedback option enables your autopilot to steer
without a conventional rudder feedback unit. This function is
designed for vessels up to 40 ft powered by outboard or stern
drives only.
- The Virtual Feedback option is only available when there is no
feedback unit connected at first time turn on, or at turn on
after an autopilot reset.
Ú
Note: Installing a feedback unit will enhance the
performance of the autopilot and provide an accurate
rudder angle indicator on the autopilot page. Unless
impractical or impossible, a rudder feedback unit should be
installed.
5. Set the drive voltage. Refer to the drive unit table in the AC12N/
AC42N Installation manual or to your drive unit documentation
for information.
6. Run the rudder test as described in the on-screen instructions.
Ú
Note: If the boat uses power assisted steering, it is
important that the engine or electric motor used to enable
the power assist steering is turned on prior to this test.
Warning: Stand CLEAR of the wheel and do not
attempt to take manual control of the wheel during
this test!
Ú
Note: When this test is started the autopilot computer
issues a series of PORT and STBD rudder commands and
automatically verifies correct rudder direction. It detects
minimum power to drive the rudder and reduces the
rudder speed if it exceeds the maximum preferred speed
(8°/sec.) for autopilot operation. The system also detects
whether the drive unit is a reversible motor or if a solenoid
valve is operated.
26
Software Setup | GO7 Installation Manual
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad GO7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad GO7 in the language / languages: English as an attachment in your email.

The manual is 2,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad GO7

Simrad GO7 User Manual - English - 122 pages

Simrad GO7 Quick start guide - English - 40 pages

Simrad GO7 Installation Guide - German - 68 pages

Simrad GO7 Quick start guide - German - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info