23322
40
Zoom out
Zoom in
Previous page
1/108
Next page
FS 20/25 Operators Manual 901-10037001/1.1
FS 20/25 Installation, System Set-Up and Test Page 4.3
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
4. FS 20/25 INSTALLATION, SYSTEM SET-UP AND
TEST
4.1 INSTALLATION PROCEDURE
The installation of the FS 20/25 Trawl Monitoring System involves the following steps:
Deciding on the locations in the wheel house for the surface units.
Mounting the surface units and making the connections between the FS 20/25
HP PC Processor, the display unit, the FS 20/25 Power Supply/TTM interface
unit, and other optional equipment being installed.
Assembling the trawl unit.
Running up the system on the test cable to verify proper installation, configure
control unit, and perform initial system test.
Installing the cable winch, snatch block and trawl cable, and connecting the
winch slip-rings to the control unit.
Mounting the trawl unit to the headrope and completing the final system test.
Mounting the catch sensors to the cod-end of the trawl.
4.2 SURFACE UNIT ELECTRONICS INSTALLATION
4.2.1 Mounting of Units
The display unit should be located in the wheel house in a place that provides a good
view of the screen and avoids direct sunlight, if possible. Depending on the monitor
that was selected, the unit may be mounted on top or recessed into the bridge
console. Simrad supplied display units include the necessary mounting brackets.
The FS 20/25 HP PC processor should be mounted in close vicinity to the operator's
position in the wheel house and near the display unit. The unit may be mounted below
or recessed into a cabinet. Note: You must have access to the ON/OFF switch.
The Power Supply/TTM interface module supplied with the system may be mounted
on top of the bridge console or recessed and flush mounted into the bridge console.
Sufficient space should be left around the control unit for proper ventilation.
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad FS25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad FS25 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info