28530
132
Zoom out
Zoom in
Previous page
1/182
Next page
Simrad ER60 Operator manual
124
850-164692 / Rev.B
Entries shown in red are frequency channels which have
previously been installed, but are no longer available.
A frequency channel can be selected by left clicking on the
entry in the list.
Transducer
The Transducer box allows you to select a transducer for the
chosen frequency channel. Transducer parameters are normally
automatically updated through the calibration procedure, and do
not need to be changed manually.
You can however manually modify transducer parameters using
the Transducer Parameters dialogue.
Transceiver information
The dialogue displays information about the chosen transceiver.
The information includes:
Name - The currently selected frequency channel
GPT SW Version - The current software version in the
General Purpose Transceiver (GPT).
Console IP Address - The IP address of the console running
the echo sounder software.
Network IP Address - Describes which numbers must be
identical between the console IP address and the transceiver
IP address for the transceiver to be identified by the console.
Thus, the address 157.237.xxx.xxx describes that all
transceiver IP addresses must start with 157.237.
GPT IP Address - Allows you to modify the IP address of
the transceiver.
Transceiver browsing
These settings allow configuration of network properties when
the system automatically searches for connected transceivers.
Local IP Address - If the computer running the echo sounder
program contains multiple network cards the network card
which is connected to the transceivers can be selected from this
list.
Remote IP Address - Normally the search for transceivers
should be broadcasted, and in this case the Remote IP Address
field must be set to 255.255.255.255 and the Communication
mode must be set to Broadcast. Changing the Remote IP
Address while selecting Communication mode Point-to-Point
can be used in special network set-ups where this is required.
132


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad ER60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad ER60 in the language / languages: English as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info