28530
126
Zoom out
Zoom in
Previous page
1/182
Next page
Simrad ER60 Operator manual
118
850-164692 / Rev.B
Max. Phase Deviation - Average electrical phase jitter between
samples inside an echo from a single target must not exceed the
max phase deviation setting where max phase deviation is set in
units of phase steps (128 phase steps = 180 electrical degrees).
Recommended setting is 2 - 3 for normal conditions. For weak
echoes in noisy conditions you should allow for more jitter (4 -
10).
Max. Gain Compensation - The correction value returned
from the transducer gain model must not exceed the maximum
gain compensation setting. (This is the one-way maximum gain
compensation. The two-way maximum compensation will be 12
dB). All single targets outside the angle corresponding to the
chosen gain compensation are skipped. Thus one can reduce the
sample volume (beam angle) by choosing a lower value for
maximum gain compensation.
Min Echo Spacing - The is the minimum spacing between two
single echos required for acceptance.
Calibration
Click the Calibration button to start the dedicated calibration
program with single target detections for this layer.
Note that you must click Apply or OK before you start the
calibration program if you have made changes to the single
target detection parameters. This is to ensure that the parameters
have been applied for the layer.
Related topics
Single Target Position view, page 9
Single Target Histogram view, page 10
Calibration procedure, page 24
126


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad ER60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad ER60 in the language / languages: English as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info