474741
33
Zoom out
Zoom in
Previous page
1/118
Next page
Operation | 31
the boat to a specific waypoint location, or through a
route of waypoints. The information received from the
navigator automatically changes the course to steer to
keep the boat on the track line and direct the AP24 to the
destination waypoint.
If the AP24 is connected to a navigation receiver that
does not transmit a message with bearing to next
waypoint, it will steer on Cross Track Error (XTE) only. In
that case you have to revert to AUTO mode at each
waypoint and manually change set course to equal
bearing to next waypoint and then select NAV mode
again.
To obtain satisfactory navigation steering, the following
points must be fulfilled prior to entering the NAV mode:
The AP24 autosteering must be tested and determined
satisfactory
The navigation receiver (GPS, chart plotter) must be
in full operating mode with adequate signal
characteristics for valid position and navigation data
At least one waypoint must be entered and selected as
the current “Go to” waypoint
The data source when operating in NAV mode is the
Navigation (Nav) source. It is normally the same as the
Position source (GPS/chart plotter) see page 49.
Navigational steering should only be used in open waters.
When selecting NAV mode, the AP24 maintains the
current set course and prompts the user to accept the
course change towards the destination waypoint.
Press the MODE key followed by the mode softkey
to activate the NAV prompt display.
MODE
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP24 Autopilot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP24 Autopilot in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad AP24 Autopilot

Simrad AP24 Autopilot User Manual - German - 124 pages

Simrad AP24 Autopilot User Manual - Dutch - 118 pages

Simrad AP24 Autopilot Installation Guide - All languages - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info