39207
70
Zoom out
Zoom in
Previous page
1/126
Next page
Simrad AP20 Autopilot
68 20220505H
Alternatively, if there is no free receptacle, cut the connector
from the cable and connect the wires in parallel with the wires
going from the junction unit to the control unit. Do not
connect the yellow and the green wire, but secure them from
connection to the terminal or chassis.
J3XX
JUNCTION UNIT
RFC35R
RATE
COMPASS
JUNCTION UNIT
MAIN PCB
Robnet
Vsys+
Vsys
GryPnk
J1
NMEA
J2
ROBNET
J3
EXT.COMP
PINK
GREY
PINK
GREY
WHITE
BROWN
Bus+
Bus
Bn
Wht
WHITE
BROWN
RATE PCB
TB15
Figure 4-14 Alternative connection to J3XX Robnet terminal
Select RFC = ROBNET in the Installation:Interface Setup.
Select RFC as compass in the User Setup Menu.
Perform the compass calibration as described on page 97.
Note ! After turn on the compass will stabilize in less than 30 seconds,
but it will need another 10 minutes to get the full effect of the
rate sensor.
Refer to page 98 to compensate for any permanent off-set after
the calibration is completed.
RFC35R calibration data is stored in the compass and will not be
deleted by a Master Reset in the autopilot. Offset compensation,
however, must be reset.
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP20 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info