39207
65
Zoom out
Zoom in
Previous page
1/126
Next page
Installation
20220505H 63
Optional bracket mounting
Locate the cradle on the mounting site and mark the 4 holes
for the fixing screws on the mounting surface.
Drill the 4 mounting holes and screw the cradle to the
mounting surface.
Use the supplied screws to fasten the control unit to the left
and right brackets.
Apply the front panel corners.
Use the two locking knobs to assemble the cradle with the left
and right brackets and adjust the control head to best viewing
angle.
Connect the Robnet cable(s) to the control unit connector(s)
(See note on page 64).
Figure 4-8 AP20 Bracket mounting
4.12 ROBNET network cables
As Robnet units have 2 Robnet connectors they can be used as
"jack points" for further expansion of the system. There are no
dedicated "in" or "out" connectors. You may connect the cables
to any available Robnet connector on the specific unit.
The Robnet cables are available in 7 and 15 m length and
provided with 6 pin male connector at one or both ends. The 15
m cable to the junction unit has connector only at the control unit
end.
Optional extension cable (10 m) is available and has a male and
a female connector.
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP20 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info