634488
15
Zoom out
Zoom in
Previous page
1/54
Next page
Installation | 13
A SimNet cable is supplied with the autopilot computer. It
has a connector only at the control unit end. The other
end is prepared for screw terminals.
AC12 Board Terminals
AC42 Board Terminals
White cable may be yellow on old SimNet cable versions!
Polarity protection
The fuse located in the lower left corner of the AC board
is not put in its final position when supplied from factory.
When the motor supply is connected to the terminal, a
diode will light. If the light is red, you have to swap the
wires. When the light is green, the polarity is correct.
Switch off the supply voltage and put the fuse into
correct position.
Radio Frequency Interference (RFI)
The autopilot system has excellent RFI protection as per
EMC Directive 2004/108/EC.
SimNet cables and other signal cables (feedback, NMEA)
should not be run in parallel with other cables carrying RF
or high current, such as VHF and SSB transmitters,
battery chargers/ generators, winches and thrusters.
If problems occur with RFI, make provisions to connect
the supply cable shield to the fast-on ground terminal.
This terminal must also be connected to the hull bonding.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AC42 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AC42 in the language / languages: English as an attachment in your email.

The manual is 2,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info