634487
19
Zoom out
Zoom in
Previous page
1/54
Next page
Installation | 17
Cylinders. The hardware may not be appropriate for other
systems.
Center the drives. Loosely secure the LF3000 to the
supplied mounting bracket, across the center of the drive
unit cylinder. Either cylinder may be used if there is a dual
set up. You may mount the feedback in either direction,
i.e. the shaft of LF3000 may point to port or starboard.
Loosen the end bolt (a) used to secure the cylinder to the
drive unit mount. Insert the rod retaining assembly (b)
and retighten the bolt. Secure the feedback rod to the
retainer plate using the two washers and the cap nut
provided. Adjust the location of the LF3000 Linear
Feedback to allow full travel of the hydraulic cylinder
without causing the retainer plate to hit the end of the
cylinder. Check that the outboard motor can be tilted
freely. Tighten all nuts and the mounting bracket.
Turn the helm slowly by hand to the stop on either side,
check that the rod does not bind up in any direction. Make
a “drip nose” (c) on the cable to the unit and clamp the
cable to allow full engine movement to port and starboard.
LF3000
BRACKET
CYLINDER
(END VIEW)
RETAINER PLATE
LOCK NUT
FLAT WASHERS (2)
LF3000
LINEAR FEEDBACK
ALLEN HEX SCREWS (2)
FLAT WASHERS (2)
MOUNTING BRACKET
CLAMPS (2 HALVES)
Figure 2-8 LF3000 mounting
c
a
b
c
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AC12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AC12 in the language / languages: English as an attachment in your email.

The manual is 2,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info