634487
10
Zoom out
Zoom in
Previous page
1/54
Next page
8 | Installation
Autopilot computer (AC12 or AC42) with accessories
SimNet cable 5,5 m (18’)
Installation accessories
AC12/AC42 Installation Manual
Compass (FC40 or RC42) with 5,5 m (18') SimNet
cable attached
Feedback unit (RF300 or RF25) with transmission rod
and cable attached.
Appropriate drive unit for the installation (unless the
autopilot is going to operate an existing drive unit or
solenoids).
Optional equipment that may have been ordered for
the installation.
2.3 Determine system configuration
It is important to become familiar with the configuration
of the system prior to beginning the installation. An
autopilot basic single station system is shown in Figure
2-1 and a system layout with options is shown in Figure
2-2
Plan your cabling and configure the SimNet network in
accordance with chapter 2.15 on page 26. Pay particular
attention to the autopilot computer/drive unit
combinations.
As most of the units are communicating on a common
network (SimNet) with identical connectors, the
installation is simple. Try to mount the units within the
standard cable length supplied with each unit. SimNet
cables are available from your distributor (see page 33)
for connection to other SimNet devices and cable
extension.
1 On boats powered by outboards or stern drives it
may be difficult to install a rudder feedback unit
(Refer to RF300, RF25 or LF3000 in this manual).
Use of the Virtual Rudder Feedback, VRF™,
algorithms in the software may then be preferred
as this requires no installation of a rudder feedback
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AC12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AC12 in the language / languages: English as an attachment in your email.

The manual is 2,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info