You need to reset the filter’s lifetime when the Filter reset button lights up and after replacing the air filter.
1. Press and hold the Filter reset button for 3 seconds.
2. Release the Filter reset button and the light will turn off, indicating the reset is complete.
5.5 Hard reset filter’s lifetime
When using the air purifier in an heavy polluted environment, the lifespan of the air filter may be significantly reduced. You can change the filter even if the Filter reset
button does not light up. Follow the steps below to perform a hard reset.
1. Unplug and replace the air filter.
2. Plug in the air purifier and keep it in standby.
3. Press and hold the Filter reset button for 3 seconds, and it will light up.
4. Press and hold the Filter reset button again for 3 seconds, and it will turn off. The reset is now complete.
5.6 UV-C bulb replacement
The UV-C lamp is designed to last approximately 5000 hours of use. The UV-C indicator on the control panel will flash RED when the operating time has been exceeded.
Note: Do not operate the air purifier without the protective UV-C bulb cover.
1. Unplug the air purifier and remove the filter.
2. Remove the cover to expose the UV-C bulb.
3. Remove and replace the UV-C bulb. Re-install the UV-C bulb cover, filter and base cover.
4. Put the plug in the wall socket and switch on the appliance again.
5. Press and hold the button for 3 seconds. After hearing ‘Ding’, the UV-C indicator will flash 3 times and then turn off. The reset is now complete.
Warning:
- The UV-C bulb contains mercury (Hg). Handle with care.
- Eye damage can be caused by looking directly at the light of the lamp when it is on.
6. Troubleshooting
Index Problem Cause Solution
7. Technical specifications
Materials PS, ABS
Size 21.5 x 33 cm
(diameter x hight)
Weight 2.5 kg
CADR smoke 150 m³/h
Coverage area 15-18 m²
Noise level 30-52 dB
Power 35W AC
Max radiated power -30 dbm
HEPA filter H13
8. Disposal
Dispose of the article and the packaging materials in accordance with current local regulations.
The crossed out wheelie bin symbol means that this product shall not be disposed of with normal
household waste. Electronic and Electrical Equipment not included in the selective sorting process
are potentially dangerous for the environment and human health due to the presence of hazardous
substances. Please dispose of responsibly at an approved waste or recycling facility.
The CE marking is a certification mark that indicates conformity with health, safety and
environmental protection standards for products sold within the European Union. The CE marking is
the manufacturer’s declaration that the product meets the requirements of the applicable EC
directives.
Recycling helps to reduce the consumption of resources and reduce the environmental impact. If
you wish to discard the packaging, comply to the environmental legislation in your country.
3
!
1
2
3
4
5
6
7
Device does not power on.
Device does not respond.
Device makes an unusual noise while
operating.
Poor air purification quality.
Filter reset button remains lit.
Device turns on, then suddenly turns off.
Device beeps repeatedly after being turned
on or plugged in.
Unit is not plugged in.
Power cord is damaged.
Device is defective or malfunctioning.
It is not turned on.
Device is defective or malfunctioning.
Filter packaging has not been removed.
Fan speed is low.
Air filter needs to be replaced.
Not enough clearance on all sides.
Air filter needs to be replaced.
Room is too large.
Air inlet is blocked.
Filter is not properly installed.
Device has not been reset correctly.
Device is defective or malfunctioning.
Connect to a power socket.
Unplug immediately and contact customer service.
Press the On/Off button to turn on the device.
Unplug immediately and contact customer service.
Remove filter from packaging before use.
Press the Speed button to adjust fan speed.
See Filter replacement section.
Ensure there is at least 38 cm (15 inches) of clearance.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Silvergear 3445 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Silvergear 3445 in the language / languages: English, German, Dutch, French as an attachment in your email.
The manual is 0.51 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
