780362
16
Zoom out
Zoom in
Previous page
1/16
Next page
15
WARNING: Be aware of the risk of open re and
other sources of strong heat, such as electric bar
res, gas res etc, in the vicinity of the cot/bed.
WARNING: Do not use the product if any part
is broken, damaged, torn or missing. Approved
replacement parts can be obtained from Silver
Cross.
WARNING: Do not leave anything in the cot/bed,
or place it close to another product which provides
a foothold or presents a danger of suffocation or
strangulation. For example strings, blind/curtain
cords etc.
WARNING: Children are likely to play, bounce,
jump and climb on beds, therefore the child’s bed
should not be placed too close to other furniture or
windows, and should be placed either tight to any
wall or have a gap of 300mm between the wall and
the side of the bed.
WARNING: Do not place this child’s bed near heat
sources, windows and other furniture.
The lowest position of the mattress base is the
safest, and should be used as soon as the baby is
old enough to sit up. To prevent injury from falls,
when the child is able to climb out of the cot, the
cot shall no longer be used for that child.
Thickness of the mattress chosen must not reduce
the internal depth (from mattress surface to top of
the side) to less than 500mm with the base in its
lower position or 200mm with the base in its higher
position.
If you leave the child unattended in the cot, always
make sure that the dropside is in the highest
position.
All assembly ttings should be tightened properly,
checked regularly and re-tightened as necessary.
Screws and bolts should not be loose because a
child can squeeze parts of the body, or clothing
e.g string, necklaces, ribbons for babies dummies
etc. could get caught. There would be a danger of
strangulation.
The cot/bed must be used on a level and stable
surface, away from electric sockets. Once
assembled do not dismantle. Never move the cot/
bed with a child in it.
Excessive chewing may damage the wood and
cause splintering. If any part is damaged stop
using until the correct replacement part has been
obtained from Silver Cross.
Your cot/bed can be cleaned by wiping with a damp
cloth and drying immediately with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia
based household polishes.
Take care when handling or moving furniture,
careless handling can damage wooden furniture.
Wood is a natural material, the colour will darken
with age.
The size of the mattress to be used with the child’s
bed is 1400x700mm.
Cot conforms to BS EN 716-1/2:2017 and
toddler bed to BS 8509:2008+A1:2011.
Cots which convert to toddler beds are intended
from birth up to approximately 4 years.
The mattress length and width shall be such that
the gap between the mattress and the sides and
ends does not exceed 30mm.
aximum 10cm thick mattress to
be used with this cot bed.
M
WARNING : Do not use more than one mattress in
the cot.
IND.1127038
IM-CMB-210202-10r02
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for silvercrossbaby Finchley Cot Bed at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of silvercrossbaby Finchley Cot Bed in the language / languages: English as an attachment in your email.

The manual is 3.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info