739832
26
Zoom out
Zoom in
Previous page
1/35
Next page
26 GB/MT
Adjusting the time
On inserting a battery, you immediately enter
the time adjustment mode (see Fig. G). Alterna-
tively, press the kg / lb / st button
7
for 3 secs
while in the time mode to enter the time adjust-
ment mode. The hour indicator flashes in the
display.
Press the temperature button
4
, to set the
hours in the 24-hour format.
Confirm your entry by pressing the kg / lb / st
button
7
. The minute indicator flashes in the
display.
Press the temperature button to set the minutes.
Confirm your entry by pressing the kg / lb / st
button
7
.
Room temperature /
time display
Press the temperature button
4
twice to switch
to temperature mode.
In the temperature mode (see Fig. H) press the
kg / lb / st button
7
to cycle between °C and °F.
After 17 seconds or pressing the temperature button
4
, the scales return automatically to the time mode
(see Fig. G).
Setting the units of weight
Note: The standard unit of weight is kilogram (kg).
The factory default setting for the scales as supplied
is “kg”.
In the weighing mode press the kg / lb / st but-
ton
7
to select the unit of weight. The units
will be displayed in the LC display as follows:
Kilogram (kg): see Figure A
Pound (lb): see Figure B
Stone (st:lb): see Figure F
Switching on your scales /
measuring your weight
Tip: Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
Place the scales down on a solid, flat horizontal
surface.
Do not place the scales on a carpet, otherwise
this may influence the results. If necessary you
can place a board on the carpet and place the
scales upon this. A solid floor covering is re-
quired in order to achieve correct weight meas-
urements.
Switch on the scales by stepping onto it.
Note: First four eights appear briefly, as
shown in Fig. I This activates the vibration sen-
sor in the scales. The scales are ready to meas-
ure your weight.
Place even weight on each leg.
If at all possible stand on the same areas of the
platform
3
each time and do not move.
Moving during the weighing process can lead
to discrepancies in the results.
The scales will start to measure immediately.
After blinking three times, the weight display
will display the result.
Note: If the scales show “ERR” (see Fig. D),
it signals that the scales are overloaded.
Observe the maximum capacity of
150 kg / 330 lb / 23 st.
Note: If the scales show „C“ (see Fig. E) when
you step off the scales, it signals that this weight
reading with an error, please measure again.
Step off the platform. The scales switch to time
mode automatically after about 20 seconds. Un-
til then the weight measurement remains visible.
Note: After a change of location and follow-
ing every battery change, the scales must be
re-calibrated. To do this, proceed as follows:
Step onto the scales. The scales will show you
an incorrect measuring result. Step off the plat-
form. The scales will calibrate automatically.
Wait until the scales switch to time mode auto-
matically.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest Z31279 IAN 75987 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest Z31279 IAN 75987 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 2,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest Z31279 IAN 75987

Silvercrest Z31279 IAN 75987 User Manual - German, Dutch, French, Italian - 29 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info