Manual Silvercrest SWS 150 A1 - IAN 73768 (page 4 of 6) (English, German, French)

565786

Zoom out

Zoom in

1/6

Connecting the USB WLAN stick

Connect the USB WLAN stick to a

free USB port on your computer.

(illustration similar)

Note: When the USB stick is connected to this USB port for the first

time the operating system will detect the new hardware and will set

up the previously installed driver.

First use

Determine which type of encryption your router/access point uses so the

USB WLAN stick can be configured accordingly.

Connecting to the router at the touch of a

button (WPS)

Wi-Fi Protected Setup (WPS) is the easiest way to connect to a WLAN

router. First, check that your router supports WPS and that this function is

enabled. For further details, please read your router's user manual.

In order to connect to the router using WPS proceed as follows:

Press the WPS button on your router. You now have a window of

approx. 2 minutes. During this time frame push the WPS button (1) on

your USB WLAN stick to make a connection between your WLAN stick

and the router.

If your router does not support WPS you can also manually configure

your WLAN stick.

The (

) icon in the notification area shows the signal strength of your

WLAN connection.

Note: If no connection is established on the first attempt repeat the

above steps.

Setting up WLAN manually (WEP/WPA)

When the software installation has completed successfully you can

configure your USB WLAN stick and connect to a WLAN router (access

point).

The following describes the WLAN set-up in Windows

7. The settings in

other Windows

operating systems may differ.

Right click the WLAN icon (

) in the notification area. A list of all

available WLAN networks will be shown.

Select the required network

(e.g. WLAN_1) by clicking

with the left mouse button.

Click on "Connect" to

establish a connection.

Enter the network security

key. Confirm your choice

with "OK".

Note: The type of encryption and the security key which protect the

network can be found in your router / access point's configuration.

Note: The network security key can be found on many routers /

access points on the underside of the device.

The WLAN connection is now established.

In this dialogue box you

determine which type of

network is used by your

access point.

The ( ) icon in the notification area shows the signal strength of your

WLAN connection.

Using the computer as an access point (virtual

WiFi)

In Windows 7 you can also configure the computer to which the USB

WLAN stick is connected as an access point. This way you can connect

other WLAN devices with your computer. The name of the network and

the network security key are determined by you on set-up.

Use the supplied drivers for set-up.

On the "Virtual WiFi" tab

select the option "Start

Virtual WiFi SoftAp"

and then click on the

"Config." button. The

following dialogue box will

be opened.

Here you can determine

the network name (SSID)

and the password. Confirm

your entries with "OK" and

then click "APPLY".

Other users are now able

to search for the network

name and establish a

connection to your access

point.

Activate Internet

connection sharing

("Setting Internet

Connection Sharing

(ICS)") to, for example,

enable multiple devices to

use this computer's Internet

connection.

The default setting is "Auto

Select Public Network".

Note: If the " Auto Select Public Network " option is deactivated, you

can manually select which networks are enabled.

Trouble shooting

The USB WLAN

stick is not

recognised.

 Check if the USB WLAN stick is correctly

inserted. Remove and re-insert the USB WLAN

stick into the USB port.

If possible use a different USB port.

 Check in the Device Manager to see if the

WLAN stick has been detected.

 If necessary, reinstall the software.

LAN connection

is not established.

 It is possible that with WPS the connection is not

directly established. Try again to establish a

connection.

 Do not use WPS and re-enter the network

security key. Pay attention to the correct spelling

(upper / lower case).

Bad WLAN

reception

Reduce the distance from the WLAN router /

access point.

Please note that other devices which work in the

2.4 GHz frequency range are able to disturb /

interfere with the signal.

Cleaning / maintenance

Only have the device repaired by qualified personnel. Only use a clean,

dry cloth for cleaning and never use any corrosive liquids. Never try to

open the housing of the device as this would void your warranty.

Environmental and disposal information

When the crossed out wheely bin symbol appears on a

product, this indicates that the product is subject to the

European Directive 2002/96/EC. All old electrical and

electronic devices must be separated from normal

household waste and disposed of at designated state

facilities. The correct disposal of old devices in this manner will prevent

environmental pollution and human health hazards. For further

information about proper disposal contact your local authorities, waste

disposal office or the shop where you bought the device.

Dispose of the packaging in an environmentally compatible manner.

Cardboard can be put out for municipal paper collections or brought to

public collection points for recycling. Films and plastic used for

packaging the device are collected by your local disposal services and

disposed of in an environmentally compatible manner.

Conformity

This device conforms with the basic requirements and other required

provisions of the R&TTE Directive 1999/5/EC.

Warranty information

Warranty of Targa GmbH

This device is sold with three years warranty from the date of purchase.

Please keep the original receipt in a safe place as proof of purchase.

Before using your product for the first time, please read the enclosed

documentation or online help. Should any problems arise which cannot

be solved in this way, please call our hotline. Please have the article

number and, if available, the serial number to hand for all enquiries. If it

is not possible to solve the problem on the phone, our hotline support

staff will initiate further servicing procedures depending on the fault.

Within the warranty period the product will be repaired or replaced free

of charge as we deem appropriate. No new warranty period

commences if the product is repaired or replaced. Consumables such as

batteries, rechargeable batteries and lamps are not covered by the

warranty.

Your statutory rights towards the seller are not affected or restricted by

this warranty.

Service

Phone: 0207 – 36 50 744

E-Mail: service.GB@targa-online.com

Phone: 01 – 242 15 83

E-Mail: service.IE@targa-online.com

Phone: 800 – 62 175

E-Mail: service.MT@targa-online.com

Phone: 800 – 92 496

E-Mail: service.CY@targa-online.com

IAN: 73768

Manufacturer

TARGA GmbH

Postfach 22 44

D-59482 Soest

www.targa.de

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SWS 150 A1 - IAN 73768 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Silvercrest SWS 150 A1 - IAN 73768 Manual

Product: