Manual Silvercrest STK 600 A1 IAN 75439 (page 48 of 54) (English, German, Dutch, French, Italian)

739755

Zoom out

Zoom in

1/54

wise it may overflow during the boiling

process.

WARNING!

• Never put alcohol, sugar or milk into

the glass pot8!

• Always allow the glass pot8 to cool be-

fore filling it with cold water. Large tem-

perature differences create large stresses

in the glass and may cause it to shatter.

1. Remove the glass pot8 from the

base14.

2. Open the lid6.

3. Remove the boiling system5.

4. Hold the boiling chamber4 tightly with

one hand, and pull the overflow1 up-

wards until the screen2 has opened the

boiling chamber, and then place the

boiling system5 on a level surface.

5. Fill the glass pot8 with the desired

quantity of water. Never fill with water

above the MAX marking9, and never

below the MIN marking10.

6. Place the desired quantity of tea into the

boiling chamber4.

7. Insert the boiling system5 into the glass

pot8. The recess in the boiling cham-

ber4 should be pointing towards the

handle7.

8. Close the boiling chamber4 by press-

ing down the screen2 at the over-

flow1. Make sure while doing so that

the riser pipe3 slots into the recess in

the bottom of the pot.

9. Close the lid6 of the glass pot8.

10.Use the On / Off switch11 to switch

the device on (I). The control light12

and the On / Off switch will light up.

You can interrupt the boiling process at

any time by switching off the device at

the On / Off switch (O) or by removing

the glass pot8 from the base14.

Depending on the volume of water, the boil-

ing process takes 6 - 10 minutes. After the

boiling process is complete (control light12

goes out), the device automatically switches

to the heating function. If the glass pot8 is

left for a long time and the contents cool

down, the tea kettle will reboil the contents.

During this process the control light will light

up again. As the contents will flow through

the boiling system5 again during this proc-

ess, you should remove it after the first boil-

ing process.

NOTE:

• Do not use green tea in the tea kettle.

The tea kettle generates a higher boiling

temperature than is required for steep-

ing green tea. The tannins released

would make the tea taste bitter.

• For proper enjoyment, drink the tea after

it has brewed the first time. If the tea is

kept hot for a long time, or if it is re-

boiled, water will evaporate and the tea

will become stronger and bitter.

• For stronger tea, add more tea to the

glass pot8; for weaker tea, add less.

• The strength of the tea depends on the

volume of water, the type of tea and the

quantity of tea used.

7. Overheating

protection

If there is no water or inadequate water in

the glass pot8 and the device is neverthe-

less switched on, this will activate the over-

heating protection, which will switch off the

heating element inside the device. The On /

Off switch11 will continue to be lit, howev-

er the device will no longer heat the con-

tents.

1. Switch off the device with the On / Off

switch11.

2. Allow the device to cool down.

3. Press the Reset button13 at the under-

neath of the glass pot8.

The device can now be reused.

__RP75439_B1.book Seite 46 Mittwoch, 27. Juni 2012 4:11 16

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest STK 600 A1 IAN 75439 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,11 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Silvercrest STK 600 A1 IAN 75439 Manual

Product: