597352

Silvercrest SNMD 33 A1 - IAN 74612 Manual

85
Zoom out
Zoom in
Previous page
1/94
Next page
GB/ IE 85
Buttonhole foot
Preparation:
Note:
To prepare the fabric:
Tips:
Remove the zigzag foot and attach the buttonhole
foot. Adjust the stitch length dial between "0.5" - "1".
The density of the stitch depends on thickness of
the fabric.
Always test sew a buttonhole.
Measure the diameter of the button and add 0.3cm
(1/8") for the bartacks. If you have a very thick
button, add more to the diameter measurement.
Mark the position and length of the buttonhole on
the fabric.
Position the fabric so that the needle is on the mark
that is furthest from you.
Pull the buttonhole foot towards you as far as it will
go.
Lower the foot.
a. Turn the pattern selector dial to " ". Sew at
moderate speed until you reach the end mark.
b. Turn the pattern selector dial to " " and sew 5-6
bartack stitches.
c. Turn the pattern selector dial to " " and sew the
left side of the buttonhole to the mark at the end
which is further from you.
d. Turn the pattern selector dial to " " and sew bar
tack stitches.
Remove the fabric from under the foot. Draw the
upper thread through the backside of the fabric and
knot upper and lower threads. Cut the center of the
buttonhole with the seam ripper, being careful not to
cut the stitches on either side.
- Slightly reduce upper thread tension to produce
better results.
- Use backing material for fine and stretchy fabrics.
- It is advisable to use a gimp cord for stretch or
knit fabrics. The zigzag should sew over the gimp.
(e)
Stitch Stitch width Stitch length
50.5~1
Sewing basics
ab cd
e
… 85 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SNMD 33 A1 - IAN 74612 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SNMD 33 A1 - IAN 74612 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info