536215
77
Zoom out
Zoom in
Previous page
1/94
Next page
GB/ IE 77
Attaching the presser foot holder
Attention:
2. Attaching the presser foot
3. Removing the presser foot
4. Attaching the edge/ quilting guide
Turn power switch to off ("O") when
carrying out any of the above operations!
1. Raise the presser bar (a) with the
presser foot lifter. Attach the presser foot
holder (b) as illustrated.
Lower the presser foot holder (b) using
the presser foot lifter, until the cut-out (c)
is directly above the pin (d)
The presser foot (f) will engage
automatically.
Raise the presser foot using the presser
foot lifter.
Raise the lever (e) and the foot
disengages.
Attach the edge/ quilting guide (g) in the
slot as illustrated.
Adjust as needed for hems, pleats,
quilting, etc.
c
d
e
f
e
g
b
a
12
3
4
Setting spool pins
The spool pins are used for holding the
spools of thread when feeding the thread to
the machine.
To use, pull up the spool pins. Push down
for storage.
A. Upper thread
B. Hole
C. Tangle
D. Spool pin
When using thread which has tendency
to tangle around a spool pin (D), thread
through the hole (B) of spool pin as
shown. The hole should face the thread
spool.
Note:
Getting ready
A
B
C
A
D
77


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SNMD 33 A1 - 74612 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SNMD 33 A1 - 74612 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info