575412

Silvercrest SMB 140 A1 - IAN 100658 Manual

7
Zoom out
Zoom in
Previous page
1/36
Next page
4
SMB 140 A1
GB
IE
Before initial use
Take the appliance out of the box and remove the
packaging material and any stickers.
Attaching the handle
1) Open the door 0.
2) Hold the handle q in front of the holes with
the pre-inserted screws on the left-hand side
of the door.
3) Push the seal 9 to one side over the holes and
screw in the screws using a Phillips screwdriver.
4) Slide the seal 9 back into the correct position
and press it fi rmly into place as required.
NOTE
►
Ensure that the seal 9 sits fi rmly in the door
frame and the door closes correctly.
Insertion of the bottle racks
■ Push the bottle rack onto the guide rails so that
the tabs on the bottle rail rest on the rear part
of the rails.
Installation
ATTENTION! MATERIAL DAMAGE!
►
Ensure that the ventilation grille is not covered
when the appliance is in use. Risk of over-
heating! Maintain a clear distance of at least
15 cm between the ventilation grilles and
other objects.
■ Place the appliance on a clean and level surface.
■ If the appliance is slightly unstable, you can
compensate for any unevenness of the surface
upon which it has been placed by means of
calibration of the adjustable feet w. To do this,
turn the relevant adjustable feet w until the ap-
pliance is stable.
Bottle sizes
This minibar is designed for standard commercial
drink bottles with a maximum length of approximately
31 cm.
Longer bottles can be stood upright in the minibar.
To do this, remove the lower bottle racks.
If a large bottle, for example, a champagne bottle,
does not fi t between the bottle racks due to its
diameter, remove the bottle rack above the bottle.
Inserting/removing the bottles
■ To insert bottles into the appliance, pull the
bottle racks out of the appliance until the tabs
stop the bottle racks from moving further along
the guide rail.
■ Then place the bottles on the bottle rack.
■ Push the bottle rack back into the appliance.
■ To remove bottles from the appliance, pull the
respective bottle rack out of the appliance until
the tabs stop the bottle rack from moving further
along the guide rail.
■ Remove the bottle and slide the bottle rack back in.
ATTENTION! MATERIAL DAMAGE!
► Do not transport the minibar unless it is empty. Remove all bottles before
transportation.
► Do not place the appliance close to open fl ames or other sources of heat
(heating, direct sunlight, gas stoves, etc.).
► Never place the appliance in a built-in cupboard, recesses or similar.
IB_100658_SMB140A1_BE.indb 4IB_100658_SMB140A1_BE.indb 4 18.06.14 15:5118.06.14 15:51
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SMB 140 A1 - IAN 100658 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SMB 140 A1 - IAN 100658 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info