576615

Silvercrest SMA 3 B1 - IAN 100079 Manual

25
Zoom out
Zoom in
Previous page
1/28
Next page
22
SMA 3 B1
GB
Use
1) Fill a tall receptacle up to approx. 1/3 with the
fl uid to be frothed.
TIPS
►
When making hot milk froth, do not heat the
milk to more than 60°C. Otherwise, the milk
will not froth up properly.
► Remember to take your fi nger off the On/
Off switch 1 before lifting the whisk 4 out
of the liquid. Otherwise, you will spray liquid
everywhere!
2) Insert the milk frother to just above the bottom
of the receptacle.
3) Press and hold down the On/Off switch 1.
The whisk 4 starts to turn. Guide it in slow
circular movements.
4) As soon as the milk froth starts forming, lift the
appliance slightly so that it always in the froth
layer.
5) When the milk is frothy enough, let go of the
On/Off switch 1 to stop the whisk 4.
6) Lift the milk frother out of the receptacle.
Changing the batteries
When the appliance’s performance becomes no-
ticeably weaker, the batteries must be exchanged.
ATTENTION! DAMAGE TO PROPERTY!
Always use batteries of the same type (1.5 V,
Mignon, AA, LR6), and never use a new battery
and an old battery together.
1) Open the battery compartment 2
2) Remove the old batteries.
3) Insert the new batteries as per the polarity
diagram in the battery compartment 2.
4) Close the battery compartment 2. Ensure that
the battery compartment cover is fi rmly in place.
Cleaning
ATTENTION! DAMAGE TO PROPERTY!
►
Do NOT use any chemical, abrasive or
aggressive cleaning agents. These could
damage the upper surfaces of the appliance.
Do not immerse the handle 3 in water!
Liquid must not be allowed to penetrate
the handle 3.
We recommend cleaning the appliance immediately
after each use. Dried-on residue can be very diffi cult
to remove.
■ Clean the whisk 4 in mild soapy water. To do
this, lower it into the washing up water and press
the On/Off switch 1 so that the whisk 4 moves
in the washing up water. Let go of the On/Off
switch 1 and rinse the whisk 4 with clean,
fresh water.
NOTE
If any dirt residue remains on the whisk 4, you
can clean this off with a cloth or washing up brush.
■ Clean the handle 3 with a moist cloth. For stub-
born soiling use a mild detergent on the cloth.
Storage
Take the batteries out of the battery compartment 2
if you are not intending to use the milk frother for
an extended period of time.
Store the appliance at a clean and dry location.
LBCH.indb 22LBCH.indb 22 18.07.14 11:2118.07.14 11:21
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SMA 3 B1 - IAN 100079 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SMA 3 B1 - IAN 100079 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info