796008

Silvercrest SKR 3W D5 - IAN 378212 Manual

31
Zoom out
Zoom in
Previous page
1/238
Next page
32 GB/IE
Requirements for the set-up
location
For the safe and trouble-free operation of the
product, the set-up location must fulfil the following
requirements:
When setting up the product, place it on a firm,
flat and horizontal surface. Use the fold-out
foot [].
The surfaces of some items of furniture might
contain components that can soften the rubber
feet of the product. If necessary, place a mat
under the product’s rubber feet.
Set up or mount the product in such a way
that the provided ventilation openings and the
loudspeaker [] are not covered.
Do not operate the product in a hot, wet or
extremely damp environment or in the vicinity
of flammable materials.
The mounting location must be selected so that
the product is not exposed to vapours. Do not
install the product directly over a hotplate.
Installation under a wall
cupboard
3.1 cm
6.3 cm
Using the supplied mounting plate [], you can
install the product e.g. under a wall cupboard.
Proceed as follows to mount the product:
Slide the mounting plate [] to the rear and
remove it from the product.
Find a suitable installation location for the
product (see “Requirements for the set-up
location”).
Hold the mounting plate [] under the
installation location. Ensure that the front edge
of the mounting plate is approx. 3.1 cm behind
the front of the cupboard so that the product is
flush with the cupboard after installation. The
side edges of the mounting plate [] must be
spaced approx. 6.3 cm away from adjacent
cabinets or walls.
Mark the 4 mounting points with a pencil.
Using a pin or nail, make a small depression at
the respective marking points. In hardwoods,
drill a hole with a depth of approx. 5mm in the
markings using a Ø 2.5 mm wood drill bit. Be
careful not to drill the hole all the way through.
If required, place the supplied spacers []
between the cupboard and the mounting plate.
If you are using the spacers [], you will need
the long mounting screws [].
Screw the mounting plate [] tight using the
mounting screws ([] or []).
With the top of the product against the
mounting plate [], push the product back until
it clicks into place.
Check to ensure that the product is properly
locked in place and safely route the power
cable and the wire aerial.
Dismantling
Pull the product forwards off the mounting
plate [].
Unscrew the screws ([] or []) on the
mounting plate and remove the mounting
plate [] from the wall cupboard.
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SKR 3W D5 - IAN 378212 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SKR 3W D5 - IAN 378212 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info