575484
7
Zoom out
Zoom in
Previous page
1/11
Next page
- 5 -
Move the swivel arm
h
the final distance to
operating position 1 (see chapter "Operating
positions") and let it engage, so that the lid is
firmly seated.
Set the rotary switch
g
to the desired level.
Risk of injury from rotating parts!
NEVER reach into the mixing bowl
y
when it is in use.
Only change accessories when the drive motor
j
is at standstill! After being switched off, the drive motor
j
continues to run for a short time. The appliance
may only be used when the drive openings not
being utilised are covered with drive protection lids.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching-on of the appliance.
Refilling with ingredients
Turn the appliance off with the rotary switch
g
.
Turn the rotary switch
g
to P and hold it firmly
until the drive motor
j
comes to a standstill
(Fig. ).
Press the unlocking button
f
down and raise
the swivel arm
h
a little.
Remove the lid.
Press the unlocking button
f
down and bring
the swivel arm
h
into operating position 5 (see
chapter "Operating positions“).
Fill with ingredients.
On task completion
Turn the appliance off with the rotary switch
g
.
Turn the rotary switch
g
to P and hold it firmly
until the drive motor
j
comes to a standstill
(Fig. ).
Press the unlocking button
f
down and raise
the swivel arm
h
a little.
Remove the lid.
Press the unlocking button
f
down and bring
the swivel arm
h
into operating position 4
(see chapter "Operating positions“).
Remove the accessories from the drive motor
j
.
Remove the mixing bowl
y
.
Clean all parts (see chapter "Cleaning and care").
Working with the food
processor
Note: Ensure that on the swivel arm
h
neither
the kneading hooks
q
, the whisk
e
nor the
mixing beater
w
are attached.
Proceed as follows to prepare the appliance for
operation with the food processor
u
:
Press the unlocking button
f
down and bring
the swivel arm
h
into operating position 4
(see chapter "Operating positions“) (Fig ).
Insert the mixing bowl
y
. The base of the mixing
bowl
y
must engage in the recesses
k
on the
appliance.
Press the unlocking button
f
down and bring
the swivel arm
h
into operating position 1
(see chapter "Operating positions“).
Remove the drive protection lid for the food
processor
u
(Fig. ).
Insert the food processor
u
into the drive opening
(The "dot" marking on the food processor
u
to
the "arrow" marking on the swivel arm
h
) and
then turn it clockwise as far as it will go (The "lock"
marking on the food processor onto the "arrow"
marking on the swivel arm
h
).
Insert the drive shaft
a
.
Depending on the task to be performed, place
the cutting
s
, rasping
o
or rubbing
i
disc
onto the drive shaft
a
of the food processor.
Place the lid with stodger
d
onto the food pro-
cessor
u
and latch it down.
Set the rotary switch
g
to the desired level.
Note: Do not press too many ingredients in the
food processor
u
. Take note of the table in the
chapter „Recommended filling quantities“.
Insert ingredients through the loading shaft with
the stodger
d
.
7


Need help? Post your question in this forum.

Forumrules
1

Forum

silvercrest-skm-550-a1---ian-56433
  • Dzien dobry,
    gdzie mozna kupic trzepak do tego robota Submitted on 24-5-2021 at 12:53

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SKM 550 A1 - IAN 56433 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SKM 550 A1 - IAN 56433 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest SKM 550 A1 - IAN 56433

Silvercrest SKM 550 A1 - IAN 56433 User Manual - German, Dutch, French - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info