737544
54
Zoom out
Zoom in
Previous page
1/77
Next page
54 GB/MT
Before getting started / Use
j To charge the device, push the ON / OFF switch
5
down to the OFF position.
j Insert the adaptor cable into the port
7
on the hair and beard trimmer and then insert
the AC adaptor plug into a suitable socket (100 - 240 V
~
).
The state-of-charge display (LED)
6
will flash red and shows the state of the charging
process.
The state-of-charge display (LED)
6
will flash green when the charging process has finished.
If the battery is fully charged, the hair and beard trimmer can be used for at least 60 minutes
without any mains power.
Note: If the rechargeable battery is nearly flat, the state-of-charge display (LED)
6
will
change colour from green to red. The hair and beard trimmer will work only for a short time.
Q
Use
Tip: The hair to be cut should be clean and dry.
j Comb your hair through carefully to remove any knots.
j Place the hairdresser’s cape or a cloth around the throat and neck to prevent hair from
dropping into the collar.
Q
Cutting hair
Tip: First cut the hair to a longer length than is required, then proceed in stages until you
achieve the desired length.
j Select and insert a comb attachment
1
. Select between comb attachments
1
that can
cut to the following lengths: 4 / 7 / 10 / 13 / 16 mm and 18 / 21 / 24 / 27 / 30 mm.
j Push the attachments onto the hair and beard trimmer over the lateral guide rails.
j Push the comb attachment
1
onto the comb attachment mounting
4
until you hear it
click into place.
j Adjust the desired cutting length by pushing the slide for the comb attachment
9
.
j Switch on the hair and beard clippers by pushing the ON / OFF switch
5
up.
j Run the hair and beard clippers slowly though your hair.
j In order to cut straight with a cutting length of more than 20 mm, the hair and beard trimmer
should be guided through the hair several times from different directions.
j When doing so, hold the hair and beard clippers in such a way that the comb attachment
1
lies as flat as possible.
j Always cut from the nape of the neck in the direction of the top of the head or from the
forehead and temples upwards towards the centre of the head.
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SHBS 600 A1 IAN 55912 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SHBS 600 A1 IAN 55912 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 4,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest SHBS 600 A1 IAN 55912

Silvercrest SHBS 600 A1 IAN 55912 User Manual - German, Dutch, French, Italian - 61 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info