738602

Silvercrest SAS 150 A1 IAN 61458 Manual

32
Zoom out
Zoom in
Previous page
1/44
Next page
32 GB/MT
Safety / Before the First Usage / Operation
Use the appliance with the supplied accesso-
ries only. No claims under the warranty nor a
liability for damages will be accepted if they re-
sult from improper or incorrect use of the slicer.
Before the First Usage
First steps
Carefully remove the electric Multi-Purpose
Slicer from its packaging, remove all packag-
ing materials and keep them together with the
main packaging.
Clean the electric Multi-Purpose Slicer before it
comes into contact with any foodstuffs (see also
the chapter ‘Cleaning’).
Setting up the appliance
Specific safety advice on the
placing of the appliance
1. Never set the electric Multi-Purpose Slicer up
on a hot surface or near an open flame.
2. Ensure that the power cable
8
does not pass
over hot or sharp-edged objects.
3. Do not allow the power cable
8
to become
kinked or trapped and do not wrap it around
the electric Multi-Purpose Slicer.
Set the electric Multi-Purpose Slicer up on a
flat, non-slip surface close to a power socket.
Unwind the required length of power cable
8
.
Insert the plug into the power socket.
Place the food carriage
10
on the supporting
table with guide slot
9
(see Fig. B). Now
press the on the blade cover
6
high standing
side down, so that the holding clamps (on the
underside of the food carriage
10
) engage. En-
sure that these have correctly engaged, in that
you check the mobility of the food carriage. Pull
to the front for removal of the food carriage
10
from the guide slot
9
and lift it from the sup-
port table
9
.
Push the food holder plate
11
on to the food
carriage
10
.
Place the catch tray
17
below the support
table
9
and on the housing such that the
sliced foods can fall in there directly and with-
out hindrance after being cut.
Adjust the infinite slice-thick-
ness setting (see Fig. D)
Through variable tightenings of the adjusting
screws
16
you can determine the movement rate
of the infinite slice-thickness setting
14
.
Screw both of the adjusting screws
16
tight
with the screwdriver
15
.
Check, by turning the infinite slice-thickness
control knob
14
, to see if the desired movement
rate is suitable.
If it is not,
- loosen both adjusting screws
16
for a lighter
movement rate or
- tighten both adjusting screws
16
further for a
stiffer movement rate.
Operation
Working advice
Specific safety advice for
slicing and for the handling of
the appliance
1. Never touch the cuttingblade
12
when the slic-
er is in operation!
There is a risk of grave personal injury!
2. Always use the food carriage
10
and the food
holder plate
11
.
(Exception: very large pieces of foodstuff).
Press the pieces of food to be sliced forward
using the food holder
11
.
3. Use the slicer only for cutting normal house-
hold foods and not for other purposes. Do not
use the slicer for cutting deep-frozen foods,
bones, foods with large kernels or for the
slicing of still packaged foods.
4. Never use the slicer continuously for more than
10 minutes .
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SAS 150 A1 IAN 61458 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SAS 150 A1 IAN 61458 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest SAS 150 A1 IAN 61458

Silvercrest SAS 150 A1 IAN 61458 User Manual - German, Dutch, French, Italian - 35 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info