118130
12
Zoom out
Zoom in
Previous page
1/30
Next page
- 10 -
Alarm Function
You can programme in two alarm times, and then
be woken by either the DAB radio, FM radio or one
of two different alarm signals.
Note:
In mains operation the functions alarm, snooze and
sleep are available without restriction.
In battery operation only the sleep function is available
without restriction. An alarm can of course be
programmed with a switched on radio, however,
it does not switch itself on from the standby mode.
Setting the alarm time
Note:
If no further input is made within 10 seconds, the display
indicates once again the previous mode of operation.
1. Press and hold the buttons
ALARM1or ALARM2to
programme the respective alarm. In the display
the indicators Alarm 1 Time Set resp. Alarm 2
Time Set and the alarm time appear. The minute
figures blink.
2. Turn the multi adjustor
VOLUME/SELECTto programme
in the minutes. Press the button
JOG MODE/SELECT.
The hour figures blink.
3. Turn the multi adjustor
VOLUME/SELECTto programme
in the hours. Press the button
JOG MODE/SELECT.
4. Turn the multi adjustor
VOLUME/SELECTto choose
between the alarm signals BEEP TONE1 or BEEP
TONE2. Press the button
JOG MODE/SELECT.
5. Turn the multi adjustor
VOLUME/SELECTto programme
in a saved position 1-10 (DAB-Preset) for the
DAB mode. Press the button
JOG MODE/SELECT.
6. Turn the multi adjustor
VOLUME/SELECTto programme
in a saved position 1-10 (FM-Preset) for the FM
mode. Press the button
JOG MODE/SELECT.
7. Turn the multi adjustor VOLUME/SELECTto programme
in a sound volume (Volume Level) from 1-20.
Press the button
JOG MODE/SELECT.
The alarm time is now programmed. To activate the
alarm, read the next section.
Activating the alarm
Repeatedly press the button ALARM1resp. ALARM2
to adjust the appropriate alarm as follows:
ON BEEP Alarm activated by alarm signal
ON DAB Alarm activated in the DAB mode
ON FM Alarm activated in the FM mode
OFF Alarm switched off
Note:
For an alarm call in the DAB mode a sender MUST
be programmed in at the selected save location.
If a sender is not saved there, then the alarm switches
itself on with a signal tone.
Note:
When the alarm is activated, a quadrat appears in
the upper left corner of the display.
With the device switched on, repeatedly press
the button
INFOuntil the indicator Alarm 1 Status
or Alarm 2 Status appears, to display the alarm
adjustments.
With an activated alarm, at the adjusted alarm time the
signal tone resp. the radio sounds for one hour.
Terminate the alarm by pressing the button
STANDBY/
ON, or deactivating the alarm by pressing the
appropriate button
ALARM1resp. ALARM2.
Snooze Function
With the snooze function you can extend the alarm
time in 5 minute steps.
Press the button
SNOOZEwhen the alarm sounds.
In the display the time and Zis indicated.
The alarm stops and sounds again after 5 minutes.
After one hour the alarm switches itself off.
IB_KH2314_AR23585_LB3C 08.09.2008 15:44 Uhr Seite 10
12


Need help? Post your question in this forum.

Forumrules
1

Forum

silvercrest-kh2314

Reset search

  • what type of power cable is used for dab radio kh2314 Submitted on 21-3-2017 at 21:48

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest KH2314 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest KH2314 in the language / languages: English as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info