738648
28
Zoom out
Zoom in
Previous page
1/40
Next page
32 GB/MT
Preparing for use
Safety advice / Preparing for use
J Exhausted or damaged batteries
can cause caustic burns upon con-
tact with the skin. To avoid this,
always wear suitable protective gloves in these
circumstances!
J Make sure you insert the batteries the right
way round (polarity). The “+” symbol must be
visible on the top of the battery.
J Batteries do not belong in the household refuse
bin!
J Every consumer is obliged to dispose of batter-
ies properly in accordance with the regulations.
J Keep batteries away from children. Do not
throw batteries into a fire. Never short-circuit
them or take them apart.
J Avoid contact with the skin, eyes and mucous
membranes if fluid is leaking from a battery. If
you come into contact with corrosive battery
fluids, flush the affected area thoroughly with
clean water and contact a doctor immediately.
J Remove the batteries from the device if they
have not been used for a long period.
J Remove exhausted batteries from the device
immediately, otherwise the batteries are likely
to leak.
J If you disregard these instructions and advice,
the batteries may discharge beyond their mini-
mum voltage, thus increasing the chance of
leakage. If your batteries leak, remove them
from the device immediately to prevent it from
being damaged!
Q
Preparation for use
Q
Removing the insulation strips
from the batteries
j Slide open the battery compartment cover
11
and take it off the battery compartment
12
.
j Remove the battery insulation strips.
j Close the battery compartment
12
with the
battery compartment cover
11
.
j If the scales do not appear to work, check that
the batteries have been inserted correctly and
reinsert them if necessary.
j When you are inserting the batteries, make
sure that you do not permanently bend the
contacts.
j Follow the instructions for inserting the batteries
as described in the section on “Replacing the
batteries”.
Q
Setting the unit of weight
Note: The default unit of weight is the kilogram (kg).
The factory default setting for the scale as supplied
is “kg”.
j Slide the switch
7
(kg/lb/st) to the desired
unit of weight.
Q
Setting the time
The value appears in the LC display
1
after
the insulation strips have been removed from the
batteries. The hour value flashes.
Note: The time is shown in 24-hour format.
Note: If you do not press a button within 30 sec-
onds, the time appears automatically as
.
j Press the
-button
3
or the -button
5
to set
the hour value.
j Confirm your settings by pressing the SET
button
4
. The minute value flashes.
j Press the
-button
3
or the -button
5
to set
the minute value.
j Confirm your settings by pressing the SET
button
4
.
Q
Switching the time
display on/off
The time display can be switched off to increase
battery life.
j Press the SET button
4
for about 5 seconds.
The hour display goes out.
j Press the SET button
4
for about 5 seconds
again. The value
appears in the LC
display
1
.
54385_silv_Digitale_Personenwaage_Content_LB5.indd 32 08.03.11 11:18
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest IAN 54385 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest IAN 54385 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 1,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest IAN 54385

Silvercrest IAN 54385 User Manual - German, Dutch, French, Italian - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info