753812
23
Zoom out
Zoom in
Previous page
1/98
Next page
21 GB/IE
Assembly
Fig. Step
Place the base unit 1 on a stable flat ground.
Avoid rugged surfaces to let the suction
cups
12
secure the base unit 1 position.
APlace the bowl 3 onto the base unit 1.
BTurn the bowl 3 counter-clockwise until it is
secured in place.
CPlace the splash guard 4 on the bowl 3.
D
Align the edges of the splash guard 4 and
the bowl 3. Secure both parts together with
the locking ring 5.
E
Place the sugar container 2 on the drive
shaft 8.
NOTE: The cross pin on the drive shaft 8
must fit into the indentation on the bottom
pin of the sugar container 2.
Operation
Connect the power plug
11
to a suitable
socket-outlet.
Switching on: Set the on/off switch
13
to I.
Allow the product to run for about 5 minutes to
reach the operational temperature.
Switching off: Set the on/off switch
13
to O.
Wait until the sugar container 2 stops turning.
Place approximately 14g sugar (not included)
into the middle section of the sugar container 2
by using the measuring spoon 9.
NOTES:
To achieve the best results, use white granulated
sugar.
Only add 1 scoop of sugar (not included) by the
measuring spoon 9 at a time to avoid overfilling
and spilling the sugar out.
Do not use the product for longer than 15 minutes
without stopping. The product could overheat and
be damaged. Switch off the product and allow it
to cool down for at least 15 minutes.
Set the on/off switch
13
to I.
After a short while sugar strands will start to form
around the inner edge of the bowl 3.
Guide the bamboo stick 6 in circles around
the bowl 3. While doing so, turn the bamboo
stick 6 in your fingers.
As soon as the sugar strand adheres to the
bamboo stick 6, lift the bamboo stick 6 above
the bowl 3 area.
Hold the bamboo stick 6 horizontally right
above the bowl 3 while turning it in your fingers
continuously.
Slowly move the bamboo stick 6 around the
edge of the bowl 3 to keep collecting all the
sugar strands.
The sugar is used up when no more strands
appear.
If you want to prepare more candy floss, switch
the product off. Refill the sugar container 2.
After use
Switching off: Set the on/off switch
13
to O.
Wait until the product cools down.
Clean the product thoroughly.
NOTE: Clean the product after every use,
otherwise the sugar residues may cause defects in
operation.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest IAN 351714 SZM 500 B1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest IAN 351714 SZM 500 B1 in the language / languages: English, German, Dutch, Danish, French, Polish, Swedish, Spanish as an attachment in your email.

The manual is 1,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info