749737
9
Zoom out
Zoom in
Previous page
1/36
Next page
GB/IE/NI/CY10
Q Protect the device against humid-
ity and penetration of liquids.
Q When disconnecting, pull the
power cable from the wall sock-
et by the power plug only, do
not jerk out the cable.
Q Do not use the device in the vi-
cinity of open flames.
Q Do not place the device directly
under or above a wall socket.
Q In the case of faults or during a
thunderstorm, pull out the con-
nector plug from the wall sock-
et.
Q Never use the device in the di-
rect vicinity of a bath tub, show-
er or swimming pool.
Q Use the device only when the
power cable is completely run
out. Never wind the power ca-
ble around the device. Make
sure that the power cable does
not contact hot surfaces. Route
the cable so that nobody can
stumble over it.
Preliminary measures prior to
starting up
Mounting the Device
Remove all packaging material and all transport
bracing from the device.
For a safe and trouble-free running of the device,
choose the installation location which meets the fol-
lowing requirements:
- The floor should be firm, flat and horizontal.
- Keep the following minimum clearances from
the device housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and 50
cm from its front side.
- Do not place the device in a hot and wet or very
humid environment or near combustible materi-
al.
- The socket should be easily accessible so that
the mains connection cable can be easily dis-
connected, if necessary.
- Temperature range: from 0 to +40 °C
- Air humidity (no condensation): 5–75 %
Please note: When you use the device the first time,
a slight odour may occur.
Starting up
Turning ON/OFF the ventilator
and heating levels
Make sure that the heating level switch 2
is set on “0”. Then connect the heater to a
grounded socket protected by a residual-
current device with overload protection. Ensure a
free rotation of the fan.
Then turn the appliance ON by clockwise turning
the temperature regulator 4 until you hear a
click and set the heating level switch 2 to the
desired position. The control light 3 illuminates.
Thus defined:
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest IAN 337147 LHL 2000 C2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest IAN 337147 LHL 2000 C2 in the language / languages: English as an attachment in your email.

The manual is 0,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest IAN 337147 LHL 2000 C2

Silvercrest IAN 337147 LHL 2000 C2 User Manual - German, Dutch, French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info