751710
35
Zoom out
Zoom in
Previous page
1/148
Next page
28 GBIE SSTB 10 C2
Set-up location requirements
For safe and trouble-free operation of the device , the set-up location must fulfil
the following requirements:
Place the device on a firm, flat and level surface.
The surfaces of some items of furniture might contain components that can
corrode and soften the rubber feet of the device. If necessary, place a mat
under the device’s rubber feet.
Do not operate the device in a hot, wet or extremely damp environment.
Keep a minimum distance of 30 cm to heat-emitting devices such as heaters,
ovens, etc.
Only operate the device in locations with adequate ventilation.
The mains socket must be easily accessible so that the plug can be easily
pulled out in an emergency.
Electrical connection
Before you connect the device, compare the connection data (voltage and
frequency) on the mains adapter type plate with that of the intended power
source. These data must agree so that no damage is sustained by the device.
Make sure that the mains adapter’s connection cable is not damaged and is
not laying over hot surfaces and/or sharp edges.
Connect the plug of the connecting cable into the connector for the power
supply on the rear of the unit and plug the mains adapter into a power
outlet. Ensure that the power cable is not stretched tightly or kinked.
Place the connecting cable such that no one can stumble over it.
Do not place the device, furniture or any other objects on the cable. Do not
kink the cable or knot it and do not connect it to other cables. Never wrap
the cable tightly around other objects otherwise the conductors inside the
cable could break and cause a malfunction.
Inserting/changing the remote control batteries
To insert/change the batteries, proceed as follows:
Pull the cover off the battery compartment of the remote control.
Remove any depleted batteries and insert two new type AAA/micro batteries
into the battery compartment. Be sure to insert the batteries with the correct
polarity.
Slide the cover back onto the battery compartment until it clicks into place.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest IAN 311937 SSTB 10 C2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest IAN 311937 SSTB 10 C2 in the language / languages: English, German, Dutch, French, Polish, Swedish as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info