664892
52
Zoom out
Zoom in
Previous page
1/62
Next page
GB
47
- Set the machine as illustrated.
- Remove the presser foot and the presser foot holder.
- Move the drop feed control to right side to lower the feed dogs. (1)
- Lower presser foot lever before starting to sew.
- Adjust the stitch width according to the size of lettering or design.
- Draw the desired lettering or design on the right side of the fabric.
- Stretch the fabric between embroidery hoop as firmly as possible.
- Place the fabric under the needle. Make sure the presser foot bar is down in its
lowest position.
- Turn the balance wheel towards you to bring up the lower thread through the
fabric. Sew a few securing stitches at the starting point.
- Hold the hoop with thumb and forefingers of both hands while pressing the
material with the middle and third fingers and supporting the outside of hoop
withe smaller finger.
* Embroidery hoop not included with machine.
Preparation for Monogramming and Embroidering*
Monogramming and embroidering with embroidery hoop*
E
0
1
2
3
4
S
0
1~5
05123 4
a
bb
a
b
2
1
Baje los dientes del transportador (NOTA: El largo no puede controlarse con el
disco).
- Ajuste la máquina según se ilustra.
- Retire el prensatelas y su soporte.
- Deslice el control del transportador de dientes al lado derecho para bajar los
dientes. (1)
- Baje la palanca del prensatelas antes de comenzar a coser.
- Ajuste el ancho de acuerdo con el tamaño de las letras del monograma o dibujo.
- Traza las letras o el dibujo deseado en el lado derecho de la tela.
- Extienda la tela dentro del bastidor con la mayor firmeza posible.
- Coloque la tela debajo de la aguja: Cerciórese de que la barra del pié
prénsatela esté en la posición mas baja.
- Gire el volante hacia usted para elevar el hilo inferior a través de la tela.
Proceda a coser unas pocas puntadas en el punto inicial.
- Sujete el aro con los dedos pulgar e índice de ambas manos.
* Coordine la velocidad de cosido y el movimiento del aro.
Preparación para la creación del monograma bordado*
Creación de monogramas y bordado con bastidor*
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silver 2003 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silver 2003 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info