664892
18
Zoom out
Zoom in
Previous page
1/62
Next page
Changing the needle (System 130/ 705H)
GB
A
B
C
D
Caution:
Turn power switch to "O" before inserting
or removing the needle.
Replace the needle at the first sign of
thread breakage or skipped stitches.
Select the correct type and size of needle
for the fabric to be sewn. Turn the balance
wheel towards you until the needle is at
highest position. Loosen the needle clamp
screw (A) and tighten again after inserting
the new needle. (1)
The flat side of the needle shaft should be
facing away from you (B).
Push the needle up (C) into the needle
clamp as far as it will go (D).
Tighten the needle clamp screw firmly.
The sewing needle must always be straight
and sharp for smooth sewing. Replace the
needle (2) if it is bent (A), blunt (B) or the
point is damaged (C).
13
1
2
AB
C
Cambiar la aguja con frecuencia, sobre
todo cuando aparezcan las primeras
dificultades en el cosido.
Montar la aguja según la ilustración:
A. Aflojar el tornillo del porta-agujas y
después de haber colocado la aguja,
apretarlo de nuevo. (1)
B. El lado plano tiene que estar hacia atrás.
C/D. Introducir la aguja hasta el tope.
La aguja tiene que estar impecable. (2)
Habrá problemas en el cosido si:
A. La aguja está torcida
B. La aguja está despuntada
C. La punta de la aguja tiene rebarbas.
Atención:
El interruptor principal debe estar en "O".
Colocación de la aguja
(sistema 130/705H)
E
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silver 2003 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silver 2003 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info