473301

Sierravideo Sierra View MADI-XX Manual

47
Zoom out
Zoom in
Previous page
1/54
Next page
SIERRA VIDEO
41
Troubleshooting
The power switch should illuminate red whenever mains power is supplied. Always ensure
that power is connected before using the problem solving guide. A spare fuse is supplied in
space provided in the IEC mains connector before the unit leaves the factory. Always replace
the fuse with one of the correct value as shown in the Installation section.
Sample problems and their solutions
There is no video output
Check that there is power to the unit and that it is turned on
Check that the video output resolution is not beyond the capability of the display (see answer
to question below)
An output should be seen within a few seconds of switching on
The image appears fuzzy or lacking clarity
If an analog or digital LCD/Plasma screen is used check that the resolution used is the same as
the native resolution of the panel. This will avoid forcing the panel to rescale the image.
Most panels produce artifacts when their internal scalers are active.
MADI-xx output resolution is set using the Screen Resolution function under the System menu.
The image is not centered in the screen
Use the monitor controls to align the image.
If an analog LCD screen is used use the auto-adjust facility.
A screen extents rectangle can be displayed to assist manual or automatic centering via the
Align Monitor Size/Pos function under the system menu.
Unit fails to respond correctly to commands
Power cycle the unit and/or perform a Master Reset
In the unlikely event that the unit fails to respond correctly, a Master Reset may be applied to
restore all settings to the factory default. Turn off the power for a few seconds, then turn it back
on while pressing both Fade/Function buttons until the bargraphs appear. This may take up to ten
seconds. Follow any required configuration steps after any reset.
The Monitor Select Cursor cannot be seen
Check that it has not been scrolled off-screen
All alarms and bargraph elements turn on in menu mode
This is done to allow configuration changes to be viewed immediately
Chapter
4
… 47 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sierravideo Sierra View MADI-XX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sierravideo Sierra View MADI-XX in the language / languages: English as an attachment in your email.

The manual is 3,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info