790187

Siemens WT48XEH9GB Manual

68
Zoom out
Zoom in
Previous page
1/76
Next page
en Help with the appliance
68
Laundry is not dried properly or
is still too damp.
■After the programme has ended, warm laundry feels damper than it
actually is. Spread out the laundry and let it cool down.
■Adjust the drying time or increase the degree of dryness. This will
extend the drying time but the temperature will remain the same.
■Select a timed programme to add extra drying time for laundry that is
still damp.
■Select a timed programme for a small load.
■Do not exceed the maximum load for a programme.~ Page 27
■Clean the moisture sensor in the drum. The sensor may become cov-
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.~ Page 59
■Drying has been interrupted as a result of a power cut, because the
condensation container is full or because the maximum drying time
has been exceeded.
Note: See also the laundry tips.~ Page 32
Drying time too long. ■The appliance may have fluff in it. This will increase the required dry-
ing time.
– Clean the base unit. ~ Page 56
– Run a complete drying cycle with a load weighing more than
3 kg. Make sure the laundry has not been pre-dried.
Note: The appliance's automatic self-cleaning function uses the
condensed water from your laundry. If you regularly dry loads weigh-
ing less than 3 kg or you regularly use the crease-removal function,
there will not be enough condensed water from your laundry to run
the appliance's automatic self-cleaning function. You should there-
fore dry loads weighing more than 3 kg on a regular basis, making
sure that the laundry has not been pre-dried.
■The heat exchanger may have fluff in it.
– Run the basic appliance care programme. ~ Page 62
■If the fluff filter is damp, this may increase the drying time and affect
the drying result. Dry the base unit's fluff filter thoroughly after rins-
ing it.~ Page 56
■If the air inlet on the appliance is blocked or not fully open, this may
increase the drying time. Make sure the air inlet remains unob-
structed.
■If the ambient temperature is lower than 15 °C or higher than 30 °C,
this may increase the drying time and affect the drying result.
■If the air circulation in the room is inadequate, this may increase the
drying time. Make sure the room is adequately ventilated.
Unpleasant odour in the appli-
ance
Run the intensive appliance care programme. ~ Page 64
Humidity in the room is increas-
ing.
Make sure the room is sufficiently ventilated.
Unusual noises when drying. When drying is in progress, the pump and compressor generate noise
when operating normally. This does not indicate that the appliance is
malfunctioning.
… 68 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens WT48XEH9GB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens WT48XEH9GB in the language / languages: English as an attachment in your email.

The manual is 3.9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info