630096
31
Zoom out
Zoom in
Previous page
1/40
Next page
Faults and what to do about them en
31
The programme will not
start.
Have you touched I button or selected f (Finish in) time?
Is the door closed?
Ó lights up: the detergent drawer has not been pushed in completely. Push
the detergent drawer in correctly.
The water is not draining. Clean the drain pump ~ Page 27
Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
Is æ (Easy iron) selected?
Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system is active – a rinse cycle has been
switched on.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the Touch-
Display.
Residual water in the left-
hand compartment for
the care product.
Not a fault – the effectiveness of the care product is not affected.
Odours, stain formation in
the appliance.
Run the ä Drum Clean programme without laundry.
Add washing powder or a detergent containing bleach.
Note: To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents designed for woollens or
delicates.
The f symbol lights up
in the Touch-Display.
Foam may also be leaking
from the detergent
drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into left-
hand compartment (not suitable for outdoor clothing, sportswear or items
stuffed with down).
Use less detergent in the next washing cycle.
Repeated, intensive foam-
ing.
Check your basic dosage and dosage strength settings.
If required, use a different liquid detergent.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill above
the max. mark in the dispensers.
Faults Cause/Remedy
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens WM14U640 - Avantgarde iSensoric at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens WM14U640 - Avantgarde iSensoric in the language / languages: English as an attachment in your email.

The manual is 5,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens WM14U640 - Avantgarde iSensoric

Siemens WM14U640 - Avantgarde iSensoric User Manual - German - 40 pages

Siemens WM14U640 - Avantgarde iSensoric User Manual - Dutch - 40 pages

Siemens WM14U640 - Avantgarde iSensoric User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info