586204
22
Zoom out
Zoom in
Previous page
1/32
Next page
en Faults and what to do about them.
22
Faults and what to do about them.
Faults Cause/remedy
Water is leaking from the
appliance.
Attach the drain hose correctly or replace it.
Tighten the threaded joint on the inlet hose.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
Start button not selected?
Is the tap turned on?
Could the filter be clogged? Clean the filter ~ Page 20.
Is the inlet hose kinked or trapped?
The door cannot be
opened.
The safety function is activated. Stop the programme?
($ Rinse stop = 2 without final rinse) selected? ~ Page 11.
Can the door only be opened by the emergency release? ~ Page 20.
The programme does not
start.
Start button for a pause or "Ready in" time pressed?
Is the door closed?
Childproof lock active? Deactivate. ~ Page 15.
The water is not draining. ($ Rinse stop = 2 without final rinse) selected? ~ Page 11
Clean the drain pump. ~ Page 19
Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault - the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the spin
because the laundry is unevenly distributed. Distribute small and large
items of laundry evenly in the drum.
Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme takes
longer than usual.
Not a fault – unbalanced load detection system adjusts imbalance by
repeatedly distributing the washing.
Not a fault – foam detection system active – a rinse cycle is activated.
The programme length
changes during the wash
cycle.
Not a fault - the programme sequence is optimised for the particular wash pro-
cess. This may result in changes to the programme length in the display field.
Residual water in the care
product dispenser.
Not a fault - the effectiveness of the care product is not affected.
Clean the insert if necessary. ~ Page 18
Odours in the washing
machine.
Run the Cottons 90 °C programme without laundry. Use standard detergent for
this.
9 symbol flashes. Foam
may be leaking from the
detergent drawer.
Have you used too much detergent?
Mix one tablespoonful of fabric softener with ½ litre water and pour into dis-
penser II (Not for outdoor fabrics, sportswear fabrics or those made with down.)
Use less detergent in the next washing cycle.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens WM14Q468 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens WM14Q468 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens WM14Q468

Siemens WM14Q468 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info