690258
17
Zoom out
Zoom in
Previous page
1/156
Next page
17
f
f
r
r
r
r
r
r
7. Holding your steam generator in the lateral position
and using a jug, ll the boiler with 1/4 litre of water
and replace the lter.
8. Shake the base unit for a few moments, unscrew the
lter again and empty the boiler completely over a
sink or bucket.
For best results, we recommend that this operation
is performed twice.
Important: before re-closing, make sure no water
remains in the boiler.
9. Replace and tighten the lter.
To reset the “Clean” counter, switch the steam
station on and off twice, keeping it off for at least 30
seconds each time.
(on 30s off on 30s off on)
Rinsing the iron steam chamber (G)
Caution! Risk of burns!
This procedure helps to remove scale particles from the
steam chamber.
Perform approximately every 2 weeks, if the water in
your area is very hard.
a) Ensure that the iron has cooled down.
b) Set the temperature to the
setting.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main power button
(9) to the “I” position, (illuminated in red).
e) Set the steam setting to
and wait until the icon
stops ashing.
f) Hold the iron over the sink or a container to collect
the water.
g) Press the steam release button (13) and gently shake
the iron. Boiling water and steam will be released,
carrying scale and/ or deposits that might be inside.
This process may take from 5 up to 10 minutes.
Please note that if you have lled the water tank to
the maximum, you do not have to continue until it is
completely empty, but just long enough so that there
are no more scale deposits appearing from your iron
hand set.
h) Set the temperature to the setting, without
pressing the steam release buttons (13-14*).
The water in the steam chamber will start evaporating.
Wait until all the water inside the chamber has been
evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over a dry cotton
cloth.
Recommended accessory
The SL45 steam station produces a high amount of
steam for best performance.
Therefore, the best additional accessory would be the
Siemens active-ironing board TN10100 / TN10200.
Cleaning & Maintenance
Attention! Risk of burns!
Always unplug the appliance from the mains supply
before carrying out any cleaning or maintenance
operation on it.
1. After ironing, disconnect the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a damp
cotton cloth.
3. If the soleplate is soiled with dirt or scale, clean it
with a damp cotton cloth.
4. If the cloth is synthetic, it may melt due to the high
temperature on the soleplate (16). Switch off the
steam and rub off any residue immediately with a
thickly folded, dry cotton cloth.
5. Never use abrasive products or solvents. To keep
the soleplate (16) smooth, you should avoid hard
contact with metal objects. Never use a scouring
pad, or chemicals to clean the soleplate.
Storing the appliance (H)
1. Always allow the appliance to cool down before
storing it.
2. Set the main power button to the “0” position (the red
light will go off) and disconnect the mains cable.
3. Place the iron on the iron pad (2), standing on the
soleplate, and x it by inserting the tip of the iron into
the front slot and moving the secureLock lever (10)
against the heel of the iron.
4. Store the mains cable (5) and steam hose (6) in the
storage compartment (4). Do not wrap the cords too
tight.
5. Use the iron´s handle when moving the appliance,
as shown in gure H, or use the carrying handles (3)
on either side.
Advice on disposal
Our goods come in optimised packaging. This basically
consists of non-contaminating materials which should
be handed over to the local waste disposal service as
secondary raw materials. Your local town council can
give you information about how to dispose of obsolete
appliances.
This appliance is labelled in accordance
with European Directive 2002/96/EG
concerning used electrical and electronic
appliances (waste electrical and
electronic equipment -WEEE).
The guideline determines the framework
for the return and recycling of used
appliances as applicable throughout the EU.
en
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens TS45200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens TS45200 in the language / languages: All languages as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info