575222
146
Zoom out
Zoom in
Previous page
1/180
Next page
146/180
Siemens Schweiz AG User Manual CE1U2354en
HVAC Products Input / output test 23. August 2007
Auxiliary functions Alarm output K10 Off
Time program 5 K13 Off
Heat demand K27 On
Refrigeration demand K28 Off
Storage tank transfer
pump
Q11 Off
After manual control has been activated, a change to the basic display must be made.
There, the maintenance / special mode symbol
appears.
Press the info button to switch to info display “Manual mode“, where the setpoint can be
adjusted.
Simulations
Line no. Operating line
7150 Simulation outside temp
To facilitate commissioning and fault tracing, outside temperatures in the range from –
50 to +50°C can be simulated. During simulation, the actual, the composite and the
attenuated outside temperature will be overridden by the set simulated temperature.
During simulation, calculation of the 3 mentioned outside temperatures continues and
the temperatures are available again when simulation is completed.
The function is deactivated by setting -.- on this operating line, or automatically after a
timeout of 1 hour.
Telephone customer service
Line no. Operating line
7170 Telephone customer service
Setting of phone number that appears on the info display.
6.23 Input / output test
Line no. Operating line
7700…7999
The input / output test is used to check the correct functioning of the connected
components.
When selecting a setting from the relay test, the relevant relay is energized, thus
putting the connected component into operation. The correct functioning of the relays
and wiring can thus be tested.
Important:
During the relay test, limitation of the boiler temperature by the electronic control
thermostat (TR) remains activated. Other limits are deactivated.
Selector sensor values are updated within a maximum of 5 seconds.
The display is made with no measured value correction.
Setpoint adjustment in
manual control
146


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens QAA 78.610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens QAA 78.610 in the language / languages: English as an attachment in your email.

The manual is 3,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens QAA 78.610

Siemens QAA 78.610 Installation Guide - German - 136 pages

Siemens QAA 78.610 User Manual - German - 64 pages

Siemens QAA 78.610 User Manual - French - 180 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info