472282
13
Zoom out
Zoom in
Previous page
1/98
Next page
Home troubleshooting
You don't always need to call the technical assistance
service. Very often you can solve the problem on your
own. The following table contains a few pieces of advice.
Important note:
Only authorised personnel from our Technical Services
Department can carry out work on the gas and electrical
supply systems.
11
Problem
Probable cause Solution
-Check the fuse in the main fuse
-The burners are wet.
-Replace the gas bottle with a full
bottle, it may be empty.
an acoustic signal is emitted?
-The safety system has been
activated, cutting off the gas
supply.
-Turn the burner control to the off
can now use your cooking hob
normally.
...if all the burners switch off
and an acoustic signal is
...if a burner switches off and
emitted?
-Overheating of cooking hob.
-Turn all the controls to the off
position. The signal will stop. Wait
30 min before using the cooking
hob again.
If the signal continues, call the
position. The signal will stop. You
Technical Service.
...if none of the electrical
system works?
-Faulty fuse.
-The automatic circuit breaker or
mains differential has been
triggered.
-Check to see if the circuit breaker
in the mains supply box.
...if the electric ignition system
does not work?
-There may be food or cleaning
product particles between the
-The covers on the burners are not
spark plugs and the burners.
in the right position.
box and replace it if it is faulty.
or a differential has been triggered
carefully.
plugs carefully.
and the burner needs to be cleaned
-Check that the covers have been
-The gap between the spark plug
...if the flame on the burners is
-The burner components have
not been assembled properly.
-The gas outlets on the burners
are dirty.
-Put the components in their
-Dry the burner covers and spark
correct positions.
-Clean the gas outlets on the
put in the proper position.
burners.
...if the gas flow does not
not evenly distributed?
seem normal or there is no
gas flow at all?
-The gas flow has been cut at
an intermediate stopcock.
-If the gas is supplied from a gas
left open.
-Possible leak on the gas
bottle coupling.
-Check to see if a valve has been
-
Open any intermediate stopcocks.
one.
...if the kitchen smells of gas? -One of the valves has been
gas bottle is in order.
left open.
-Check that the coupling on the
...if all the burners switch off
and an acoustic signal is
emitted?
-Detection of a general fault.
If it does not, call the
-After a minute, a beep will sound.
Technical
Service.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens HK48064 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens HK48064 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 11,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info