527327
20
Zoom out
Zoom in
Previous page
1/32
Next page
20
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
: Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
1.Switch off the fuse in the fuse box or unplug at the mains.
2.Turn the cover anti-clockwise to remove.
3.Remove the bulb and replace with a bulb of the same type.
4.Slide the new seals and the clamping ring onto the glass
cover in the right order.
5.Screw the glass cover with the seals back on again.
6.Connect the appliance to the mains and reset the clock.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Turning the temperature selector cancels
the cooking operation
A temperature outside of the possible tem-
perature range has been set
Check the temperature ranges for the
operating modes. Press the
button
0 and :‹‹ light up in the display
Power cut Reset the clock time (see section: "Time-
setting options")
”‰ is shown in the display
The automatic safety switch-off is active Press any button.
The
¯ indicator appears even though the
water tank is full
The water tank has not been pushed in
properly
Slide in the water tank until it engages
The detection system is not working Call the after-sales service
The
¯ indicator appears even though the
water tank is not yet empty, or the water
tank is empty but the
¯ indicator does not
appear
The water tank is dirty. The mobile water
level indicators are jammed
Shake and clean the water tank. If the
parts cannot be released, obtain a new
water tank from the after-sales service.
The water tank empties for no discernible
reason. The evaporator dish is overflowing
The water tank was not closed properly Close the lid until you feel it engage.
The tank cover seal is dirty Clean the seal
The seal in the tank cover is defective Obtain a new water tank from the after-
sales service
The evaporator dish has boiled dry even
though the water tank is full
The water tank has not been pushed in
properly
Slide in the water tank until it engages
The feed line is blocked Descale the appliance. Check whether the
water hardness is set correctly
The
¯ indicator appears
The appliance has not been used for at
least 2 days and the water tank is full
Empty and clean the water tank. Always
empty the water tank after cooking
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam
This is normal.
When you cook with steam, a lot of steam
is created
The appliance is being automatically cali-
brated
This is normal.
When cooking with steam, a lot of steam is
created again
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Reset the appliance to the factory settings
(see Basic settings section). Then start
steaming at 100 °C for 20 minutes
Steam escapes from the ventilation slots
during cooking
This is normal.
The appliance is not producing steam
properly
Limescale has formed in the appliance Start descaling (see Section: Descaling)
Error message
“‹‚‚ appears in the dis-
play
A button was pressed for too long or is
jammed
Press the
0 button to clear the fault mes-
sage. Press each button and check that it
is clean
An
... error message appears in the dis-
play
Technical fault.
Press the
0 button to delete the error
message. Reset the clock if required. If the
error message appears again, call the
after-sales service
The appliance is not heating. The colon
flashes in the display
A button combination was actuated Set the Steam operating mode to 35 °C,
then press and hold the
@ button until a
signal sounds. Press the
@ button again
briefly
Problem Possible cause Notes/remedy
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens HB34D553 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens HB34D553 in the language / languages: English as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens HB34D553

Siemens HB34D553 User Manual - German - 32 pages

Siemens HB34D553 User Manual - Dutch - 32 pages

Siemens HB34D553 User Manual - Danish - 32 pages

Siemens HB34D553 User Manual - French - 36 pages

Siemens HB34D553 User Manual - Italian - 36 pages

Siemens HB34D553 User Manual - Polish - 36 pages

Siemens HB34D553 User Manual - Portuguese - 36 pages

Siemens HB34D553 User Manual - Swedish - 32 pages

Siemens HB34D553 User Manual - Spanish - 36 pages

Siemens HB34D553 User Manual - Norwegian - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info