504633

Siemens Gigaset A420A Manual

19
Zoom out
Zoom in
Previous page
1/24
Next page
19
Gigaset A420-A420A / Großbritannien / A31008-M2402-L101-1-7619 / Bali.fm / 04.08.2014
Template Bali, Version 1, 16.02.2012
Questions and answers
If you have any queries about the use of your telephone, visit our website at www.gigaset.com/service
for 24-hour support. The table below contains a list of common problems and possible solutions.
Contact with liquid
If the handset has come into contact with liquid:
1 Switch the handset off and remove the battery immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry,
warm place for at least 72
hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is completely dry.
When it has fully dried out, you will usually be able to use it again.
Problem Cause Solution
Nothing appears on
the display.
The handset is not switched on.
The batteries are flat.
Press the end call key a for approx. 5 seconds or place
the handset in the base station.
Charge or replace the batteries.
No wireless connec-
tion to the base sta-
tion, Base flashes in
the display.
The handset is outside the range of
the base station.
The base station is not turned on.
Move the handset closer to the base station.
Check the mains connector on the base station
¢ page 3.
The display shows
Register HS or Put
into base.
Handset has not been registered
with the base station or has been
de-registered.
Register the handset ¢ page 13.
Handset does not
ring.
The ring tone is deactivated.
The phone only rings if the phone
number has been transferred.
The phone does not ring in a spe-
cific time period.
Activate the ring tone ¢ page 16.
Activate the ring tone for anonymous calls ¢ page 15.
Deactivate the "Time Control" or change the time period
¢ page 15.
You cannot hear a
ringer/dialling tone
from the fixed line
network.
The phone cord supplied has not
been used or has been replaced by
a new cord with the wrong jack
connections.
Please always use the phone cord supplied or ensure
that the pin
connections are correct when purchasing
from a retailer: 3-4 assignment of telephone leads/
EURO
CTR37.
Error tone sounds
after system PIN
prompt.
PIN forgotten.
The system PIN you have entered is
incorrect.
Reset the system PIN to the default 0000 ¢ page 16.
All handsets are de-registered. All settings are reset.
All lists are deleted.
!
… 19 …


Need help? Post your question in this forum.

Forumrules
1

Forum

siemens-gigaset-a420a

Reset search

  • The manual says thet the call list can be set for either missed calls or the last 25 calls. How do I set it for the last 25 calls? Submitted on 25-8-2020 at 20:20

    Reply Report abuse

  • The manual says that the call list is either missed calls or the last 25 calls. How do I set it for the last 25? Submitted on 25-8-2020 at 20:18

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens Gigaset A420A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens Gigaset A420A in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens Gigaset A420A

Siemens Gigaset A420A User Manual - German - 24 pages

Siemens Gigaset A420A User Manual - Dutch - 24 pages

Siemens Gigaset A420A User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info