Manual Siemens EX677FEC5E (page 25 of 32) (English)

790957

Zoom out

Zoom in

1/32

en Energy consumption indicator

[Energy consumption

indicator

Ener gy c onsumpt i on i ndi c at or

This function indicates the total amount of energy

consumed by this hob the last time it was used for

cooking.

Once the hob is switched off, the energy consumption

is displayed in kilowatt hours (e.g. ‚.‹‰ kWh) for 10

seconds.

The accuracy of the information displayed depends on

the voltage quality of the mains power supply, among

other factors.

You can find out how to switch this function on in the

section on ~ "Basic settings"

tCookware check

Cook war e chec k

This function can be used to check the speed and

quality of the cooking process depending on the

cookware.

The result is a reference value and depends on the

properties of the cookware and the hotplate being used.

1. Correctly position the pot with approximately 200 ml

of water, at room temperature, on the most suitable

cooking zone for the diameter of the bottom of the

pot.

2. Go to the basic settings and select the setting ™‚ ƒ.

3. Press the programming area. A flashes in the

cooking zone displays.

The function has now been activated.

After 10 seconds, the cooking result and the speed of

the cooking process appear in the visual displays for

the cooking zone.

Check the result using the following table:

To reactivate this function, touch the settings range.

Notes

■The flexible cooking zone only counts as a single

hotplate; place no more than one item of cookware

on it.

■If the diameter of the hotplate used is much smaller

than the diameter of the cookware, only the middle

of the cookware can be expected to heat up. This

may result in the cooking results not being as good

as expected or being less than satisfactory.

■You can find information on this function in the

section on ~ "Basic settings".

■You can find information on the type, size and

positioning of the cookware in the sections on

~ "Induction cooking" and ~ "Flex Zone".

Result

‹The cookware is not suitable for the hotplate and will therefore

not heat up.*

‚The cookware is taking longer to heat up than expected and the

cooking process is not going as well as it should.*

ƒThe cookware is heating up correctly and the cooking process

is going well.

* If there is a smaller hotplate available, test the cookware again on the

smaller hotplate.

Power manager en

hPower manager

Power manager

You can use the power manager to set the total power

of the hob.

The hob is preset at the factory. Its maximum

performance is specified on the rating plate. You can

use the power manager to change the value in

accordance with the requirements for the relevant

electrical installation.

In order not to exceed this set value, the hob

automatically distributes the power available between

the cooking zones that are switched on.

As long as the power manager function is activated, the

output of a cooking zone may temporarily fall below the

nominal value. If a cooking zone is switched on and the

power limit is reached, ¬ appears in the heat setting

display for a short time. The appliance automatically

regulates and selects the highest possible power level.

For more information about how the total power of the

hob is changed, see section ~ "Basic settings"

DCleaning

Cl eani ng

Suitable maintenance and cleaning products can be

purchased from the after-sales service or in our e-Shop.

Hob

Cleaning

Always clean the hob after cooking. This will prevent

food deposits from becoming burned on. Only clean the

hob after the residual heat indicator has gone out.

Clean the hob with a damp dish cloth and dry it with a

cloth or towel to prevent limescale build-up.

Only use cleaning agents that are suitable for this type

of hob. Observe the manufacturer's instructions on the

product packaging.

Never use:

■Undiluted washing-up liquid

■Cleaning agents designed for dishwashers

■Abrasive cleaners

■Harsh cleaning agents, such as oven spray and

limescale remover

■Scouring pads

■High-pressure cleaners or steam jet cleaners

Stubborn dirt is best removed with a glass scraper,

available from retailers. Observe the manufacturer's

instructions.

You can obtain a suitable glass scraper from customer

services or through our online shop.

Using a special sponge for cleaning glass-ceramic

hobs achieves a great cleaning result.

Note: Do not use any cleaning agents while the hob is

still hot. This may mark the surface. Make sure that any

residue left by cleaning agents is removed.

Hob surround

To prevent damage to the hob surround, observe the

following instructions:

■Only use warm soapy water

■Wash new dish cloths thoroughly before use.

■Do not use harsh or abrasive cleaning agents.

■Do not use a glass scraper or sharp objects.

Potential marks

Limescale and water

marks

Clean the hob as soon as it has cooled down.

You can use a cleaning agent suitable for

glass-ceramic hobs.*

Sugar, rice starch or

plastic

Clean immediately. Use a glass scraper. Cau-

tion: Risk of burns.*

* Then clean with a damp dish cloth and dry with a cloth or towel.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Siemens EX677FEC5E in the language / languages: English as an attachment in your email.

The manual is 4.54 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens EX677FEC5E

Siemens EX677FEC5E User Manual - German - 32 pages

Siemens EX677FEC5E User Manual - Dutch - 64 pages

Siemens EX677FEC5E User Manual - French - 36 pages

Siemens EX677FEC5E User Manual - Italian - 64 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Siemens EX677FEC5E Manual

Product: