791009
11
Zoom out
Zoom in
Previous page
1/36
Next page
en Getting to know your appliance
10
The control panel
Touch controls
Touching a symbol activates the associated function.
Notes
Always keep the control panel clean and dry.
Moisture reduces its effectiveness.
Do not place any cookware near the indicators or
sensors. The electronics could overheat.
The hotplates
Residual heat indicator
The hob has a residual heat indicator for each hotplate.
This indicates that a hotplate is still hot. Do not touch a
hotplate while the residual heat indicator is lit up.
The following indicators are shown depending on the
amount of residual heat:
Display : High temperature
Display œ: Low temperature
If you remove the cookware from the hotplate during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the hotplate is switched off, the residual heat
indicator will light up. Even after the hob has been
switched off, the residual heat indicator will stay lit for as
long as the hotplate is still warm.
Selection sensors
#Main switch
»Selecting the cooking zone
0 IIIIIIIIIIII Settings area
&PowerBoost function
Intensive ventilation settings
üCombiZone function
ÿMove function
ÑLocking the control panel for cleaning
'Childproof lock
0Time-setting options
IManual hood control
Display
Operating status
-ŠPower levels
‹‹ Time-setting options
/œResidual heat
PowerBoost function
Intensive ventilation setting I
.Intensive ventilation setting II
üCombiZone function
ÿMove function
xCooking timer
VTimer
öTime indicator
Cooking zones
"Single cooking zone Use cookware that is a suitable size
¯Combined cooking zone See the section entitled ~ "CombiZone function" or ~ "Move function"
Only use cookware that is suitable for induction cooking; see the section entitled ~ "Induction cooking"
Operating modes en
11
ÇOperating modes
Oper at i ng modes
This appliance can be used in air extraction mode or
circulating-air mode.
Exhaust air mode
Note: The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Circulating-air mode
Note: To bind odours in circulating-air mode, you must
install an activated carbon filter. The different options for
operating the appliance in circulating-air mode can be
found in the brochure. Alternatively, ask your dealer.
The required accessories are available from specialist
outlets, from customer service or from the Online Shop.
KBefore using for the first
time
Bef or e us i ng f or t he f i r st ti me
Please read the following information before using the
appliance for the first time:
Clean the appliance and all accessory parts thoroughly.
Before you can use your new appliance, you must apply
certain settings.
Switch the hob on and off using the main switch #.
Setting the operating mode
The appliance is supplied with a preset air recirculation
mode.
When the hob is installed with an air outlet to the
outside, you must configure the setting ™‚ˆ in this
mode. See section ~ "Basic settings".
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens ED811FQ15E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens ED811FQ15E in the language / languages: English as an attachment in your email.

The manual is 4.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens ED811FQ15E

Siemens ED811FQ15E User Manual - German - 28 pages

Siemens ED811FQ15E User Manual - Dutch - 68 pages

Siemens ED811FQ15E User Manual - French - 36 pages

Siemens ED811FQ15E User Manual - Italian - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info